Operation Manual

EasyGuard IP200
CAM use DHCP function and very often there is a DHCP server on most of the
Home/office network, the IP CAM should be connected to the Internet immediately.
The Internet status LED is constant red light to indicate this good connection status.
If the LED is blinking, please refer to section 3.3~3.5 to try other network settings.
Figure 2-3: IP CAM connection diagram.
Figure 2-4: Connect Ethernet cable to a switch/router.
Second, Install the CamView software on the notebook/PC
Please insert the installation CD into the CD-ROM drive in your notebook or