ACTION CAMCORDER Functions This user's manual has referred to the latest information we had when this user’s manual was made. The screen display and illustrations are used in this user's manual for the purpose of introducing details of this digital camera in a more specific and direct way.
Announcements Please read the Announcements carefully before using this video camera for proper and safe operation, so as to bring its optimum performance into play and extend its service life. u Do not expose the video camera to sunshine directly, nor point its lens to sunlight. sensor of the video camera may be damaged.
Please use the cleaning agent of video camera for wiping if necessary. Do not use organic solvent to clean the video camera. u Do not touch the lens surface with fingers. u Please back up the data if the memory card inside this video camera is used for the first time. u The externally installed memory cards are manufactured from precise electronic components. Data may be lost or damaged under the following circumstances: 1. Improper use of the memory card. 2.
Waterproof Case Using Notice u Before sealing the waterproof case, keep the camera housing’s rubber seal clean, a single hair or grain of sand can cause a leak. You can test by closing the case without inserting the camera. Submerse the case completely in water for about a minute. Remove the case from the water, dry off its exterior with a towel, then open the case. If the entire interior is dry, the case is safe for use under water.
System Requirements Operating System CPU Internal Memory Sound Card and Display Card CD Driver Hard Disk Others System Requirements Microsoft Windows2000, XP, Vista, 7 Intel Pentium III of more than 800MHz or other CPU with equivalent performance Larger than 512MB The sound card and display card shall support DirectX8 or higher version. Speed of 4 times or faster Free space of more than 500MB One standard USB1.1 or USB2.
Appearance and key introduction Mode switch: -Photograph -Video -Replay Lens Power On/Off Shutter Charging indicator Operation indicator Up key LCD TFT OK key Down key 5
Key/Indicator Power On/Off Function Power the camera on or off. When opening the menu, switch over between normal (effect parameters and replay of image, video) and setup menu. In recording video mode, it is used to start/stop recording. In capture mode, it is used Shutter as a shutter. In replay mode; it is used to play the video. When operating the menu, it is used to confirm the selection.
Usage 1. Charge the built-in lithium battery Charger indicator lights USB Cable Connect the video camera with computer for charging in the shutdown state. The indicator light for charging is on at this time and will be off after charging. In general, it can be fully charged after 2-4 hours.
2. Use of Memory Card 1. Push the memory card into the card slot according to the concave lettering beside the slot of memory card till it is completely inserted. 2. To take out the memory card, gently press the end of the memory card inward and it will pop up. Note: No built-in memory is available in this video camera. Make sure to insert memory card before using.
3. Startup/Shutdown 3.1 Startup: Press the POWER button for 3 seconds, the screen is displayed and the camera is on. 3.2. Shutdown: Press the POWER Key, and the camera will be shut down. . Automatic shutdown: when the idle time of the video camera reaches the time for automatic shutdown, it will be shut down automatically to save power. The default time of this camera for automatic shutdown is 5 minutes. 3.3.
4. Conversion between Function Modes Three modes are available for this video camera, i.e. picture taking mode, video recording mode and vehicle-mounted mode. Conversion is available via the mode switch after startup. Picture taking mode: pictures can be taken; Video recording mode: video can be recorded; Vehicle-mounted mode: videotape can be recorded.
5. Indicator light Busy light: when the camera is busy (such as, recording a film, taking photos, automatic off-screen), the busy light will be on. Charging light: when the light is on for a long time, it prompts the user that the camera is charging. 6.
4 5 6 : movie size: indicates the current movie size is 720P. : means that the memory card is inserted at present. : magnification of digital zoom: press Up and down key to adjust zoom among 1x-4x. 7 : battery icon, represents the power status of the battery. 8 9 : white balance icon: indicates the current white balance mode is automatic. metering icon: indicates it is currently the pan overall perspective metering.
Video menu options Main menu Video format Sub-menu 1280x720 640X480 Off 1min Recording int 3min Metering mode Central metering Multi-point metering Point metering 5min White balance Automatic Daylight Description High resolution format. Medium resolution format. Power-off driving record. Set driving record to 1 minute as a repeating phase. Set driving record to 3 minutes as a repeating phase. Set driving record to 5 minutes as a repeating phase. Metering subject to the central area.
Cloudy Fluorescent light Tungsten light Normal White and black Sepia Special effect Date stamp Negative film Suitable for cloudy environment. Suitable for fluorescent light source environment. Suitable for tungsten light source environment. Normal effect. White and black effect. Sepia effect. Negative film effect. Red Reddish effect. Green Greenish effect. Blue Bluish effect. Off Turn off printing date/time on the file.
7 Driving video recording: Push Mode switch to Video mode, open the menu, press Down key to select “REC interval” menu, press Shutter key to enter sub-menu, “1min, 3min, 5min” recording loop mode are for free selection. After pressing OK key for confirmation, press OK key again to exit from the menu. When Shutter is pressed, it starts video recording.
Note: After selecting OFF in “REC interval” menu, the camera turns to normal video recording. Normal recording is beyond the limit of time, and it will not stop until the memory card is full. 8 Picture taking mode: Switch the mode switch into the Picture taking mode, press the shutter button or click the LCD center once under the previewing state to take a photo: 1 2 3 4 5 6 7 8 9 9999: Counter, indicating current number of photos taken already /number of photos to be taken.
Capture menu setup In capture mode, press OK key to open menu, and then press Up and Down key to select menu. When selecting menu, background of the selected item will be highlighted. Press Shutter to enter sub-menu. In sub-menu, press Up and Down key for selection, press Shutter for confirmation and back to main menu. In the main menu, press OK key to exit from the menu.
Capture menu options Main menu Image size Image quality Metering mode Sub-menu 2592x1944 2048X1536 1280X1024 Excellent Good Normal Central metering megapixel resolution Point metering Automatic White balance Daylight Cloudy Fluorescent light Tungsten light Description 5 megapixel resolution. 3 megapixel resolution. 1 megapixel resolution. Best quality image. Good image quality. General quality image. Metering subject to the central area. Metering subject to multi-points. Metering subject to one point.
Exposure Capture mode / Off Use general single shot mode. 2s Use 2sec. delay self-timer mode. 10s Continuous shooting` Use 10sec. delay self-timer mode. Use continuous shooting. Normal White and black Sepia Special effect Date stamp Use Left and Right key to adjust exposure compensation. Negative film Normal effect. White and black effect. Sepia effect. Negative film effect. Red Reddish effect. Green Greenish effect. Blue Bluish effect. Off Turn off printing date/time on the file.
Date / time During capturing/recording video, print date and time on right bottom corner of the file. 9 Playback mode: 9.1 After power-on, push Mode switch back to Playback mode: 1 2 mode icon: indicates it is currently the mode of playback. : Indicates that there is one file in current folder/totally one folder. 3 4 : indicates that the current folder is locked. : indicates the current file is a video file.
9.2 Playback menu setup In playback mode, press OK key to open menu, and then press Up and Down key to select menu. When selecting menu, background of the selected item will be highlighted. Press Shutter to enter sub-menu. In sub-menu, press Up and Down key for selection, press Shutter for confirmation and back to main menu. In the main menu, press OK key to exit from the menu.
Playback menu options Main menu Sub-menu Lock Lock/unlock this file Lock all Unlock all Lock/unlock this file. Lock all files. Unlock al files. Delete this file Delete the current file. Delete Slide Show Description Delete all Start Interval Repeat Delete all files. Start playing slide show. 1sec.~10sec. Yes/No. 9.3 Movie clips playing: During playing, press Shutter key to play, press Up key for pause, press Shutter key to stop playing.
9.4 Delete file: 1) After selecting the file to be deleted, open the menu, press Up and Down key to select “Delete”. 2 Press Shutter key to enter, after selecting “One”, press Shutter key for confirmation). “All” means to delete all files.
3) After selecting “Yes”, press Shutter key to delete the file. When the file is deleted, press OK key to exit from the menu. 10 System setup menu: In capture, video recording or playback mode, press OK key to open menu, and then press Power key to switch over to setup menu. In setup menu, press Up and Down key for selecting menu. When selecting menu, background of the selected item will be highlighted. Press Shutter to enter sub-menu.
System setup menu options Main menu Sub-menu Automatic playback Off 1 second 3 seconds Power frequency Automatic shutdown Description No playback performed after capture. Playback performed 1 second later after capture. Playback performed 3 seconds later after capture. 50Hz Set to 50Hz light source frequency. 60Hz Set to 60Hz Playback performed 1 second later after capture. 1 minute 3 minutes 5 minutes Automatic shutdown performed in case of 1 minute idle.
Setting date and time: Press OK key to open the menu, and then press Power key to enter setup menu. Press Down key to select “Date&Time” item, and press Shutter key to enter setup window. In setup window, press Power key to select the item to be adjusted (Date, time). The selected item will be highlighted in yellow. Then press Up key or Down key for adjustment. At completion of adjustment, press Shutter key to confirm the adjustment, or press OK key to cancel the setup and return.
Apply on the personal computer Connect to personal computer The camera is provided with the plug and play function. Connect the device to the computer with USB line under turning-on state, then it will be switched into the movable hard disk mode. Icon of movable disk will appear on the window of “my computer”. Photos/videos you have taken are saved in folder I:\DCIM\100MEDIA (I is the movable disk of this device) in the movable disk. Files recorded in vehicle-mounted mode are saved in I:\DCIM\RECORDER.
Technical parameters Image sensor Function mode Camera lens Digital zooming Shutter LCD display 1.3 million pixel (CMOS) Video, capture, car mode, portable disk, PC cam F3.1 f=9.3mm 4x Electronic shutter 1.77” (4.5cm) Image resolution 5M (2592×1944), 3M (2048×1536), 1M(1280×960) Video resolution White balance Exposure VGA: 640x480 (60 frames/second), 720P: 1280x720 (30 frames/second) Automatic / Sunny / Cloudy / Fluorescent light / Tungsten light -2.0 ~ +2.
This symbol indicates that the relevant electrical product or battery should not be disposed of as general household waste in Europe. To ensure the correct waste treatment of the product and battery, please dispose them in accordance to any applicable local laws of requirement for disposal of electrical equipment or batteries.
DECLARATION OF CONFORMITY easypix herebly declares that the product GoXtreme Race Mini is in conformity to all the essential requirements of Directive 1999/5/EC. The declaration of conformity can be downloaded here: http://www.easypix.info/download/pdf/doc_goxtreme_race_mini.pdf For technical help please visit our support area on www.easypix.eu.
