User’s Manual
CONGRATULATIONS! You have purchased one of the smartest and smallest devices with a unique hand-flexing operation feature. The lightweight and compact wrist watch style device can be operated conveniently with a simple flex of your wrist.Its ideal to stay connected with family or friends at parks, shopping malls, sporting events, concerts-virtually any indoor or outdoor activities.
LCD Screen 1.Channel Number, Displays current channels 2.CTC: display 38 CTCSS/83 DCS sub-channel 3.Battery Level indicator: display battery status 4.Time: will display time mode 5.Channels: Display channels 6.Volume level: Adjustable 8 volume level 7.Receive Indicator (RX)-Indicates when unit is receiving transmissions 8.Transmit Indicator (TX)-Indicates when unit is transmitting. 9.Channel scan 10.Alarm clock 11.Call Tone Transmission (CALL)-Indicates When unit is paging. 12.
Important: Changes or modifications to this unit not approved by manufacturer/Communication Authority could void your right to operate this unit. Your communicator is set up to transmit a regulated Signal on an assigned frequency. It is against the law to alter or adjust the settings inside the communicator to exceed those limitations. Any adjustment to your communicator must be made by qualified technicians. QUICK GUIDE 1. Insert the battery 2.
communicator to the OFF position to prevent accidental transmission when in a blasting area or in areas posted : “Turn off two-way radios.” Construction crews often use remote control RF devices to set off explosives. CARE AND SAFETY To clean your communicator, use a soft cloth dampened with water. Do not use cleaners or solvents; they can harm the body of the unit and leak inside, causing permanent damage. Use a dry, lint-free cloth to clean the battery contacts. Do not submerge the unit in water.
CHARGING THE BATTERY Caution：Do not use charger before inserting battery!!! Your communicator comes with an A/C Adapter charger to charge your Lithium-Ion battery. To charge: 1. Lift the Headset/Charger Jack Cover located on the side of your unit 2. Connect the A/C Adapter Charger into an A/C Wall outlet 3. Insert the A/C Adapter Charger into the Headset/Charger Jack. During charging the Low Battery Level icon will appear on the display, and will disappear once the battery is fully charged .
NAVIGATING THROUGH THE MENU To access the advance features, your communicator has a Menu with two functions. Watch Mode 1.To enter or exit watch Mode, press the Power key for around 3 seconds. A long keybeep tone is locally generate(after a short keybeep tone) when the unit goes into Watch Mode and the LCD will display the time segments and battery icons for the watch. Communication Mode. 1.
To set the Time（watch mode） Your Communicator has a 12/24-hour Time Clock, which can be set as follows: 1. In Communication mode, enter to Menu mode by long time pressing the Menu key until a short key-beep tone is heard. When the time Setting mode is engaged, the Hour segment in the LCD Display will flash. 2. Press the Menu button 7 times, screen will display 12/24-hour mode setting, by press S button to start to set, press Up or Down key to select 12 or 24H mode.
during transmit operation, your radio will automatically transmit to the repeater on channel 2. Turning on/off duplex on channels: A. select the required channel to suite the repeater station you wish to access(channels from 1~8 and 41~48) B. Press the MENU button twice, RPT icon will display in screen C. Press UP or Down button to set the duplex function to On or Off D. Press PTT button to confirm your setting. E.
seconds and it can only be possible to operate once in any 60 seconds period ■Choosing Frequency, channel Your Communicator have built-in 8 countries frequency and 38 group of CTCSS subchannels, 83 group of DCS sub-channels for each channel for communicating with others. You can use only communicate with other radio users tuned to same channel and sub-channel 1.
1. Press the Scan key found on the side of the unit. Once engaged, the unit will start to rapidly scan the whole channels of the communicator for any activity. The unit will pause on an active channel for 4~5seconds before resuming Scan function. 2. To exit the Scan mode, press the Yellow button. ■CALL TONE setting Press Menu button 4 times, screen will display CALL character, digital 01 keep flashing, by press UP or down button to select call tone from 01~10, press PTT button to confirm call tone setting.
Transmitting and Receiving To use your communicator to communicate with others: 1.In Communicator Mode, the unit is continuously in RECEIVE mode. 2.Press and hold the Yellow Button and speak as you normally would, holding the microphone about 2~3 inches away from your mouth. 3. When you are finished speaking, release the Yellow Button. You are now ready to receive incoming transmissions. While receiving transmission, the R X icon appears on the display.
• Alarm function in the communication mode: After setting the alarm function in watch mode, an alarm icon will appear in the lower left corner in the communication mode. When the alarm starts you can stop it by pressing any button. If you do not press any button it will automatically stop after 1 minute. Remark: Time, date and alarm function can only be adjusted in the watch mode, not in the communication mode.
PROBLEMS AND SOLUTIONS PROBLEM No power SOLUTION ·Check the battery. Ensure that the battery is installed Properly. ·Battery may be weak. ·Recharge your battery by using the A/C Adapter Charger ·Your battery may be damaged. Replace old Battery with a new Lithium-Ion battery. Weak Reception ·Press the UP button to increase VOLUME. ·The receiving signal may be weak and/or out of range. ·Check the antenna position.For optimum performance. Make sure the antenna is pointing upright.
P.R. China (20ch) Ch. Frequency Ch. Frequency Ch. Frequency Ch. Frequency 1 409.7500 7 409.8250 13 409.9000 19 409.9750 2 409.7625 8 409.8375 14 409.9125 20 409.9875 3 409.7750 9 409.8500 15 409.9250 4 409.7875 10 409.8625 16 409.9375 5 409.8000 11 409.8750 17 409.9500 6 409.8125 12 409.8875 18 409.9625 USA(22ch) Ch. Frequency Ch. Frequency Ch. Frequency Ch. Frequency 1 462.5625 7 462.7125 13 467.6875 19 462.6500 2 462.5875 8 467.5625 14 467.
Australia（80ch） Channel 01* 41* 02* 42* 03* 43* 04* 44* 05* 45* 06* 46* 07* 47* 08* 9 48* Tx Rx Freq Freq MHZ MHZ 476.4250 476.4250 - 476.4375 476.4500 476.4500 - 476.4625 476.4750 476.4750 - 476.4875 476.5000 476.5000 - 476.5125 476.5250 476.5250 - 476.5375 476.5500 476.5500 - 476.5625 476.5750 476.5750 - 476.5875 476.6000 476.6000 - 476.6125 Channel 21 61＊＊ 22＊ 62＊＊ 23＊ 63＊＊ 24 64 25 65 26 66 27 67 28 68 16 Tx Rx Freq Freq MHZ MHZ 476.9250 476.
49 10 50 11 51 12 52 13 53 14 54 15 55 16 56 17 57 18 58 476.6250 476.6250 476.6375 476.6375 476.6500 476.6500 476.6625 476.6625 476.6750 476.6750 476.6875 476.6875 476.7000 476.7000 476.7125 476.7125 476.7250 476.7250 476.7375 476.7375 476.7500 476.7500 476.7625 476.7625 476.7750 476.7750 476.7875 476.7875 476.8000 476.8000 476.8125 476.8125 476.8250 476.8250 476.8375 476.8375 476.8500 476.8500 476.8625 476.
19 59 20 60 476.8750 476.8750 476.8875 476.8875 476.9000 476.9000 476.9125 476.9125 39 79 40 80 477.3750 477.3750 477.3875 477.3875 477.4000 477.4000 477.4125 477.4125 Important note: The operation of your UHF radio in Australia and New Zealand is subject to conditions in the following licenses: In Australia the ACMA radio communications(Citizen band radio stations) and in new Zealand by MED the general user radio license for citizen band radio.
Ch. Frequency Ch. Frequency Ch. Frequency Ch. Frequency 1 448.7500 8 448.8375 15 448.9250 22 449.2250 2 448.7625 9 448.8500 16 448.1500 23 449.2375 3 448.7750 10 448.8625 17 449.1625 24 449.2500 4 448.7875 11 448.8750 18 449.1750 25 449.2625 5 448.8000 12 448.8875 19 449.1875 6 448.8125 13 448.9000 20 449.2000 7 448.8250 14 448.9125 21 449.2125 38 CTCSS CODE LIST CODE Frequency(Hz) CODE Frequency(Hz) OFF OFF 20 131.8 1 67.0 21 136.5 2 71.
12 100.0 32 203.5 13 103.5 33 210.7 14 107.2 34 218.1 15 110.9 35 225.7 16 114.8 36 233.6 17 118.8 37 241.8 18 123.0 38 250.3 19 127.3 Customer can design channels. SPECIFICATIONS Power Source 3.7V/650mAH Lithium-Ion Battery Output Power (TX) 0.5W ERP maximum Range 6.0 Kilometers （can make range as long as expected by customer by provide extra service） For technical help please visit our support area on www.easypix.eu.
