User`s manual

DC-200 RAID card User’s Manual
E31/E43
5. Installing drivers when installing the Operating System
If you are installing a new operating system on a freshly created array or hard
drive connected to the DC-200, follow these procedures.
5.1 Installing the DC-200 RAID card driver when installing Windows 98
or Windows ME
Install the operating system first. When the Windows 98 or Windows ME
setup is finished, the installation procedure for the DC-200 driver will be
the same as in an existing Windows 98 or Windows ME operating system.
(Please refer to 4.1)
5.2 Installing the DC-200 RAID card driver when installing Windows
2000 or Windows NT
You will install the driver during the operating system installation. Please
take the following steps to install the driver with the operating system.
1. Begin with the diskette installation or CD-ROM installation.You will see
a message like that underlined below when booting:
‘Setup is inspecting your computer’s hardware configuration…’
Press ‘F6’ a few times at this screen.
2. Press ‘S’ at the following screen, then select ‘Other’ and press ’Enter’.
3. Insert the DC-200 RAID card driver Installation diskette and the system
will search for the drivers automatically and show them on the screen.
4. Select drivers for the operating system (Windows NT or Windows 2000),
then install the driver.
5. After the driver installation procedure is complete, the installation of
Windows NT or Windows 2000 can continue normally.
After installing operating system and rebooting, if you can see ‘Tekram
DC-200 ATA/100 RAID Controller’ at ‘SCSI Adapters’ of ‘Control Panel’,
installation of DC-200 Driver is successful.