Specifications

OfficeServ 7200 System Description

Front View of MP20

The front view of the MP20 is shown in the figure below:

Figure 2.3 Front View of the MP20

The components on the front panel of the MP20 have the functions below:

Table 2.5 Ports and LEDs of the MP20

Ports, LEDs Functions

LINK1~LINK3 Ports that connect the MP20 with the LCP.

MISC1~MISC2 Ports that connect external music sources, paging device, loud bell, common

bell, or door bell.

LAN Port for establishing the 10/100 BASE-T Ethernet connection.

SIO UART port (for tests).

Media Card Port for installing the NAND-type flash memory.

RUN LED This LED indicates the status of the MP20.

- Off: Power is not connected.

- On(Green): Booting.

- Blink(Green): The Program is operating properly.

- Blink (Red): Fan module failed.

- Blink (orange): Reset button is pushed.

- ON (orange): Flash Memory (Data base) clear

LAN LED This LED indicates the status of the connection to LAN.

- Off: MP20 is not connected to LAN.

- On: MP20 is connected LAN.

- Blink: MP20 is transmitting or receiving Data through LAN port.

MC LED This LED indicates the status of the Smart Media/Media Card access.

- Off: The SD Card is not installed.

- On: The SD Card is installed, however is not accessed.

- Blink: The SD Card is installed and is being accessed.

LCP LED This LED indicates the status of signaling message processing.

- Off: There’s no message exchange between MP20 and LCP.

- On: Messages are being sent/received to/from the LCP.

RST Button for resetting the MP20 board.

Button for Data base clear when pushed more than 7second

Media Card

RST

MC LCP

RUN LAN

LINK 1

LINK 2

LINK 3 MISC1

MISC2

LAN

SIO

MP20