Specifications

OfficeServ 7200 System Description

The components on the front panel of the TEPRIa have the functions below:

Table 2.10 Ports and LEDs of the TEPRIa

Ports, LEDs Functions

P1 Port 1 that connects the T1/E1/PRI cable

LAN Port that connects the 10/100 BASE-T LAN (for tests)

SIO UART Port (for tests), CPLD JTAG Port (for managements)

RUN LED Green Light: When operating in E1/T1/PRI mode (blinks at a rate of 200 ms)

Orange Light: When operating in debug mode (blinks at a rate of 200 ms)

SYN1 LED Indicates the status of the synchronization with the opposite switchboard.

- On: The frame synchronization with the opposite switchboard is incorrect

- Off: The frame synchronization with the opposite switchboard is correct

LOS1 LED Indicates whether the opposite switchboard has a Loss of Signal (LOS).

- On: The opposite switchboard signal is small or suffers from a loss of signal

- Off: The opposite switchboard signal is received normally

AIS1 LED Indicates whether the board received the alarm bit of the opposite switchboard.

- On: The board received the alarm bit of the opposite switchboard

- Off: The board did not receive the alarm bit of the opposite switchboard

L21 LED Indicates the operation status of Layer 2.

- On: The Layer 2 is operating properly

- Off: The Layer 2 is operating abnormally

TP1 LED Indicates the type of the program running on Port 1

- On: The Port 1 is operating in PRI mode

- Off: The Port 1 is operating in T1/E1 mode

CLK LED Turns on when the reference clock is used as the system clock.

RST Button for resetting the TEPRIa.