User`s manual

46
Doppler MPT Users Manual
Revision A
Receiver Pass Through
0x0017
Various
Sends command directly to receiver
Sweep 0x0018 byte Nibble 0 : Direction
0 = CW
1 = CCW
Nibble 1: Sweep State
0 = Sweep Off
1 = Sweep On
Manual command to start the sweep
Used in factory testing. Not recommended for use by user.
Calibrate S Meter 0x0019 byte 0 – 9 Callibrates S-meter to the level indicated. Works only with
receivers having an analog RSSI output
Filter 0x001A byte 0 = Off, 1 = On Enables or disables the audio filter that removes the antenna
sweep rate tone
Reserved for future use
0x001B
Hold Time 0x001C byte Hold time in seconds Time DF holds the bearing calculation
DF Sends 360 when hold time expires
Default 5 seconds
DHCP 0x001D byte 0 = do not use DHCP
1 = use DHCP
IP Address 0x001E 4 bytes Sets the IP Address If using DHCP this sets the default IP address.
Default 10.0.0.100
IP Gateway
0x001F
4 bytes
Sets the IP Gateway
Default 255.0.0.0
IP Subnet Mask
0x0020
4 bytes
Sets the IP Subnet Mask
Defa
ult 10.0.0.1
IP DF Port
0x0021
UINT16
Sets the port for the DF communications
Default 2101
Send Rx Settings
0x0022
0
Gets the frequency, volume, and squelch settings
Set to Default 0x0023 0 Sets all parameters to their default values (IP
parameters exc
luded)
Reset Processor 0x0024 0 Restarts the processor
(All ip connections will be terminated)
Reserved
0x0025