X1 USER'S MANUAL Please watch operation video in Website or YouTube Channel:Easythreed3D
Thanks for purchasing Easythreed X1 3d printer, it’s a 3d printer machine for beginners, enjoy the happiness of creation. 1，Printer Specifications 1.
1.2 Basic Parameter Print Basic Parameter Operation Environment Working Temperature: 5℃～35℃ Relative Humidity: 30%～ 90% Electrical Parameter Power Input :100～240V AC, 50/60Hz； Power Output:12V/DC,5A Maximum Power :30W Nozzle Diameter 0.4mm Print material PLA Extrude temperature 180-230℃ Recommend Temperature PLA：180℃ Print speed 10~40MM/S Layer thickness 0.05~0.
3 , Power on Insert our X1 provided power cable to power port at the side of the printer control box，electricity connected successfully when the light inside button is on。(Precaution: the USB port is preserved by our technical person for firmware updated , please do not use it ; If printing finished or no need to use for quite a long time, take off the power cable to power off) 4，Slicer software application (STL format 3D file need be sliced to gcode format that printer can recognize). (1).
（2）Load Filament , feed (a),Insert filament into the print head tube until it can not go further,and gently press the filament to stop it runs back. (b),Click button,the button light turn on and flash，the nozzle is heating , Please be patient and wait about 2 minutes, the machine begin to feed, when there is regular silk come out of the nozzle, feed succeed, Then you can press button to finish feed. Note: Make sure the distance between the nozzle and printing bed is 3cm at least .
（3）Print Insert the TF card to the printer, Click button, and the button light will flash, Please be patient and wait about 2 minutes, printing starts( the Printer will choose the lastest gcode file to print automatically) . （4）Pause/Restore during printing, Click ,the button light stops flashing , then printing paused. If need to continue print , Click to restore, the button light flashes again , the printer goes back to print .
moving parts when Mercury is working . 6. Maintenance 6.1 Do not use the methods that is not mentioned in this manual to disassemble or modify this machine , to avoid damage to this printer or may cause other serious accident . 6.2 When the power is off , regularly clean the machine with a piece of cloth to wipe off dust and residue , if the cloth is wet , do not use inflammable liquid to contact the inner circuit to avoid fire or electronic shock . 6.
equipment turns off such as air conditioner , if so , you need to connect a voltage stabilizer to the printer power supply. Otherwise, observe if the nozzle is blocked at a certain position, if so , the power supply on X,Y,Z axles are not even, then need to adjust the X,Y, Z electric current on the main board. A5 , If the above solution can not solve the misplace problem, the dislocation mostly happen at the same height for various models , then need to change the mother board .
