Operating instructions

4 Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com

REquIRED ITEMS

Before you begin using the Eastwood TIG Welding System, make sure you have the following:

• Our TIG200 is supplied with the popular NEMA 50P plug, requiring a NEMA 50 receptacle. If a 220-240 VAC, 30 Amp outlet

is used a UL listed 30 Amp plug may be installed by a licensed and qualiﬁed electrician.

• The TIG200 will also operate on a 110-120 VAC 20 Amp circuit. To operate on this voltage it is necessary to connect the included

adaptor cord to the plug hard wired to the TIG200.

• A clean, safe, well-lit, dry and well-ventilated work area.

• A non-ﬂammable, long sleeve shirt or jacket (Eastwood #12762L, XL, XXL).

• Heavy Duty Welding Gloves (#12590)

• An Auto Darkening Welding Mask (Eastwood #13203 or equivalent) to provide eye protection during welding operations.

NOTE: MUST be a #11 lens or darker.

• A compressed gas cylinder containing 100% Argon (must be used when TIG welding and is available at any welding supply facility).

• Dedicated stainless steel wire welding brushes for each material to be welded.

• A dedicated ﬁne grit synthetic stone grinding wheel or a Tungsten Sharpener.

POwER REquIREMENTS

The Eastwood TIG200 AC/DC is Voltage sensing; it will automatically operate on 110-120 VAC, 50/60 Hz., or 220-240 VAC, 50/60

Hz. Eastwood recommends at a minimum a properly grounded 110-120 VAC 50/60Hz., 20 Amp circuit or 220-240 VAC 50/60Hz.,

30 Amp circuit.

BEFORE YOu BEGIN

Remove all items from the box. Compare with list below to make sure unit is complete.

• TIG200 AC/DC Welder with NEMA50-P Plug

• Shielding Gas Regulator

• Shielding Gas Hose

• Ground Cable with Clamp (10’)

• TIG Torch (17 Series) which accepts industry standard cups, collets and collet bodies (14’)

• Foot Pedal for Amperage Control

• 110-120 VAC to 220-240 VAC Adaptor Plug

• Instruction Manual

• Hand Held Shield

• Hammer/Brush

• #7 Gas Nozzle (7/16”)

• #6 Gas Nozzle (3/8”)

• #5 Gas Nozzle (5/16”)

• Long Back Cap

• Short Back Cap

• 3/32” Collet Body

• 3/32” Collet

• 1/16” Collet

• 2.0mm Collet

• 2.0mm Red (Thoriated Tungsten)