Cut Sheet

Junction Boxes
Type 1 Screw Cover - Painted & Galvanized
Data and Illustration Sheet
Finish
• Wash and phosphate undercoat or galvanized steel
• ANSI 61 gray acrylic electrocoat finish
Accessories
• Ground lug kit
• Touch-up paint
• See Accessories section
Construction
• Enclosure and cover are fabricated from code gauge steel
or galvanized steel, (see table)
• Enclosure body has mounting holes on the back
• Enclosures are available with or without knockouts on the
sides, top and bottom ends
• Cover is secured to the body with plated pan head combo screws
• Keyhole slots provided in the cover allow easy access to the
inside without removing the screws
• Hole provision for optional ground lug kit
• Ground screw provided
Discount Schedule: A2
Subclass: AN0 (painted) & AX1 (galvanized)
knockout area
(see table for pattern,
see detail for size)
knockout area
(see table for pattern,
see detail for size)
∅ .25
(6)
mounting
hole (4PL)
B (**B)
B-1.00
(25)
B
C
A (**A)
A-1.00
(25)
A
Dimensions:
**A = (-1.90) if 16 or 14 gauge
(-3.90) if 12 gauge
**B = (-2.00) if 16 or 14 gauge
(-4.00) if 12 gauge
Application
• Used as wiring boxes, junction and pull boxes
• Protects against contact with enclosed equipment
Standards
• UL 50 listed, Type 1
• CSA C22.2 No. 40 certified, Type 1
• Conforms to NEMA standard for Type 1
Type 1, 3, & 3R Enclosures
Notes: We can provide special sizes, finishes and other modifications. Consult the factory for your special requirements.
Dimensions are in inches. Millimeters shown are for reference only. Data subject to change without notice.
Front View
Side View
Bottom View
50
Type 1, 3, & 3R Enclosures
B-Line series electrical enclosuresEaton