Cut Sheet
Type 1 Screw Cover Wireway - Painted & Galvanized
Data Sheet
Construction
• Wireway body and cover are fabricated from code gauge steel
or galvanized steel, (see table)
• Wireway body has mounting holes on the back
• Wireway is available with or without knockouts on the top and
bottom sides
• Wireway fittings have no knockouts, ends are available with or
without knockouts
• Cover is secured to the body with plated screws
• Keyhole slots are furnished on the wireway cover which allow
easy access to the inside without removing the screws
• Flush and surface wireway covers are available
• Wireway exceeding 72 inches in length has two overlapping
covers
• Variety of fittings allow runs which can change direction,
junction and terminate
• Standard wireway connectors (sold separately) have a unique
gate feature which can swing completely open allowing for
continuous runs of wire and cable
• Universal connectors are also available for adapting to other
manufacturer’s wireway, (see table, page 16)
• Completely interchangeable with Type 1 Hinge Cover Wireway
and Fittings
Application
• Houses runs of control and power cable
• Used for cable and wire junction, distribution and
termination
Standards
• UL 870 listed, Type 1
• CSA C22.2 No. 26 certified, Type 1
• Conforms to NEMA standard for Type 1
• IEC 60529, IP30
Finish
• Wash and phosphate undercoat or galvanized steel
• ANSI 61 gray acrylic electrocoat finish
Accessories
• Sealing devices
• Touch-up paint
• See Accessories section
Notes: Cooper B-Line can provide special sizes, finishes and other modifications. Consult the factory for your special requirements.
12
Wireway
Wireway