Cut Sheet

Pushbutton Enclosures
Type 12 - 22.5 mm & 30.5 mm
Data and Illustration Sheet
Wash and phosphate undercoat
ANSI 61 gray polyester powder finish
Stainless steel enclosure cover and sides of body have a
smooth brushed finish
Hole seals
Columns and bases
Touch-up paint
See accessories section
Enclosure and cover are fabricated from (14) gauge steel,
Type 304 or Type 316L stainless steel
All continuous welded seams are finished smooth
Cover is attached with captive screws which thread into sealed
well nuts (stainless enclosures use stainless sealed well nuts)
Cover has concealed, detachable hinges which allow for quick
removal and can be hinged on either side (not offered on all
Cover has a fixed, oil-resistant gasket
Weldnut in body of enclosure for grounding
Cover is pre-punched with standard 30.5 mm or miniature
22.5 mm “4-way” pushbutton holes
External mounting feet are provided for secure wall mounting
Discount Schedule: C2
Subclass: DP0
Designed to mount standard 30.5 mm or miniature
22.5 mm oil-tight pushbuttons, pilot lights and switches
Protects against circulating dust, falling dirt and
dripping non-corrosive liquids
UL 508 listed, Type 12 and Type 13
CSA C22.2 No.94 certified, Type 12 and Type 13
Conforms to NEMA standard for Type 12 and Type 13
1.203 D
.190 (TYP)
Standard 4-Way
.886 D
.125 (TYP)
Miniature 4-Way
Operator Enclosures
Operator Enclosures
PBxx Series
PVxSS Series
Notes: We can provide special sizes, finishes and other holes and cutouts, see page 352. Consult the factory for your special requirements.
B-Line series electrical enclosuresEaton

Summary of content (2 pages)