Specification Sheet

SLD6068xxWH
SLD6069xxWH
HALO
*This is a representative list of compatible junction boxes only. Information contained in this literature about other manufacturers’ products is
from published information made available by the manufacturer and is deemed to be reliable, but has not been verified. Eaton makes no specific
recommendation on product selection and there are no warranties of performance or compatibility implied. Installer must determine that site conditions
are suitable to allow proper installation of the SLD mounting bracket in the box.
4" square deep steel box
4" x 4" x 2-1/8"
(102mm x 102mm x 54mm)
COMPATIBLE WITH MANY OTHER JUNCTION BOXES*
COMPATIBLE WITH EATON’S CROUSE-HINDS JUNCTION BOXES
4" octagon light fixture/fan
steel box
4" x 4" x 2-1/8"
(102mm x 102mm x 54mm)
• TP316 - for non-metallic cable
• TP317 - for metal clad cable
• UL Listed
• Suitable for two-hour fire-rated ANSI/UL 263 when properly
installed in a fire-rated ceiling or wall
• Refer to www.crouse-hinds.com
TP316
for non-metallic cable
4” x 4” x 2-1/8”
(102mm x 102mm x 54mm)
TP317
for metal clad cable
4” x 4” x 2-1/8”
(102mm x 102mm x 54mm)
4" round new work non-metallic box
with hanger bar assembly
4" diameter x 2-3/16" (102mm x 56mm)
3-1/2" round old work
non-metallic box
4-1/4" O.D. flange, 3-1/2" I.D. x 2-5/8”
(108mm O.D., 89mm I.D. x 67mm)
4" round new work
non-metallic light fixture/
fan box
4" diameter x 2-3/16"
(102mm x 56mm)
3-1/2" round new work
non-metallic ceiling box
3-1/2" diameter x 2-3/4"
(89mm x 70mm)
4" square standard
steel box
4" x 4" x 1-1/2"
(102mm x 102mm x 38mm)
4" octagon steel box
4" x 4" x 1-1/2"
(102mm x 102mm x 38mm)
4” round surface mount box
4" diameter x 1-1/2”
(102mm x 38mm)
Requires SLD6RAD adapter
Surface mounting in a fire-rated ceiling using an appropriate electrical box offers a cost-effective alternative to fire-rated recessed housings.
Note: Fire-rating is per the rating of the ceiling and applicable junction box, not the SLD.