User's Manual

XXXXX-01 5 Eka 900SiP User’s Guide
Warning
T o c omply with FCC RF exposure compliance requirements, the antenna
used for this transmitter must be installed to provide a separation distance of
at least 22.4 cm from all persons and must not be co-located or operate in
conjunction with any other antenna or transmitter.”
As such, the radio component of this device is intended only for OEM
integrators under the following two conditions:
The antenna must be installed such that 22.4 cm is maintained between the
antenna and users.
The transmitter module may not be co-located with any other transmitter or
antenna.
As long as the two conditions above are met, further transmitter testing will
not be required. However, the OEM integrator is still responsible for testing
their end product for any additional compliance requirements required with
this module installed (e.g., digital device emissions, PC peripheral
requirements).
In the event that these conditions cannot be met (for example, co-location
with another transmitter), then the FCC authorization is no longer considered
valid and the FCC ID cannot be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the
end product (including the transmitter) and obtaining a separate FCC
authorization.
End Product Labeling
This transmitter module is authorized only for use in devices where the
antenna may be installed such that 22.4 cm may be maintained between the
antenna and users (for example access points, routers, wireless ASD L
modems, certain laptop configurations, and similar equipment). The final
end product must be labeled in a visible area with the following: “FCC
ID: P9X-900SIP”.
The radio component is an integral part of the Eka module and cannot
be removed.