Cut Sheet

Volume 8—Sensing Solutions CA08100010E—November 2012 www.eaton.com V8-T6-7
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6.1
Conveyor Sensor Systems
E68 Series Integral Sensor Valve
Accessories
Cables
Sensor Output Cables
Power Supply Cables
Release Cables
Length Description Used with Sensors Catalog Number
Beam Status Output Cable
1m Wires from the beam status output connector on the
sensor to a remote PLC or other controller
E68….-xyz-B E68-SVABEAM-1
Length Description Used with Sensors Catalog Number
Power Supply “T” Connection
2m This cable allows the power supply to be connected
between any two zones, while allowing use of those zones.
For best results, the power supply cable should be
connected at the center of the zones being powered.
Tinned leads on power supply end.
E68….-xyC E68-SVAPWR-C2
E68….-xyP E68-SVAPWR-P02
12 mm DC-key connector on power supply end. E68….-xyP E68-SVAPWR-P2
Power Supply Cable
2m This cable allows the power supply to be connected to
any zone, while allowing use of that zone. For best results,
the power supply cable should be connected at the center of
the zones being powered.
E68….-xy BUS266PWR-01B1
50m E68….-xy BUS266PWR-5001B1
Power Supply
— 27 Vdc, 100W; short-circuit, overload and overvoltage
protection (cycle power to reset). Power supply can
normally power up to 50 ISV zones. See PG.05.06.T.E
for more details.
E68…. PS256A-01B1
Length Description Used with Sensors Catalog Number
Release Cable—With Release and Power Connection
2m This cable is connected to the last zone and allows
singulate or slug discharge control from an
external system.
Both release and power connections are provided. If the
power connections are used, a separate power supply “T”
cable is not needed.
E68….-xyC E68-SVAREL2-C2
E68….-xyP E68-SVAREL2-P2
Release Cable—With Release Connection Only
2m This cable is connected to the last zone and allows
singulate or slug discharge control from an
external system.
Release connections only are provided.
E68….-xy BUS266REL-01B1
Release Cable—With Release and Power Connection
2m This cable is connected to the last zone and allows
singulate or slug discharge control from an
external system.
Both release and power connections are provided. If the
power connections are used, a separate power supply cable
is not needed.
E68….-xy BUS266REL-02B1
Beam Status
Output Cable
Power Supply
“T” Connection
Power Supply Cable
Power Supply
E68-SVAREL2-_
BUS266REL-01B1
BUS266REL-01B1