Owner`s manual

14
Figure 4.1 — Composite pad
When mounting the generator to concrete, there are four mounting holes available for securing the generator, if codes require (two holes inside the
front of the generator compartment and two holes in the back). See Figure 3.2.
Figure 4.2 — Mounting Hole Location
4.1.1 FASCIA INSTALLATION (IF APPLICABLE)
• Locate the four (4) threaded black rubber bumpers located in the Owner’s manual bag.
• Remove the four (4) bumpers from the bag and screw them into threaded holes located inside the end pieces of the fascia (two each) opposite
one another (A).
• Once the bumpers are installed, snap one of the end pieces into one of the front/rear pieces of fascia. Repeat this action with the other two
remaining pieces of fascia. NOTE: Do not assemble all four pieces together at this point (B).
• Place both assemblies at the base of the generator and fi t the rubber bumpers into the lifting holes in the generator base (C).
• Once aligned, snap together the two remaining connection points.