User`s manual

500 - 1400 VA
User’s Manual
1015715
Revision B
10
3. Operation and Configuration
Turning the UPS On
To turn on the UPS, press the button on the front panel (shown in Figure 4). After
the UPS is turned on, it conducts a self–test and enters Normal mode. The
indicator
illuminates indicating that power is available from the UPS output receptacles.
Starting the UPS on Battery
To turn on the UPS without using utility power, press and hold the button for two
seconds. When the UPS starts on battery, it does not conduct a self–test to conserve
battery power.
NOTE
The UPS does not automatically detect the input frequency when starting on
battery. The default frequency for 230V models is 50 Hz;
Turning the UPS Off
To turn off the UPS, press the button on the front panel and then unplug the UPS
from the power outlet. If you do not unplug the UPS, it remains in Standby mode.
Standby Mode
When the UPS is turned off and plugged into a power outlet, the UPS is in Standby
mode. The battery recharges when necessary and the indicator is off, indicating that
power is not available from the UPS output receptacles.
UPS Front Panel
The UPS front panel indicates the UPS status and also identifies potential power
problems. Figure 4 shows the UPS front panel indicators and controls. If the alarm
beeps or any alarm indicators are on, see Table 3 on page 17 to identify and correct the
problem.
Figure 4. UPS Front Panel
On/Off Button
Test/Alarm Reset Button
Power On Indicator
On Battery Indicator
Overload Indicator
Service Indicator