User`s manual

500 - 1400 VA
User’s manual
1015715
Revision B
11
Initiating the Self–Test
Press and hold the button for three seconds to initiate the self–test. If the UPS finds a
problem, an LED indicates where the problem is. For more information, see
“Troubleshooting” on page 17.
NOTE
The UPS must not be in Battery mode to perform the self–test.
Voltage Configuration
The DIP switches on the rear panel of each unit (see Figure 5) are used to configure the
output voltage and input voltage range.
1. The UPS must be completely shutdown.
Turn the UPS off by pressing the button on the front panel and then unplug
the UPS.
2. Set the DIP switches according to the configurations in Table 1.
3. Plug the UPS into a power outlet and press the button to turn the UPS on.
Figure 5. DIP Switches
Table 1. DIP Switch Settings
UPS Rear Panel
egatloVtuptuO egnaRegatloVtupnI 1hctiwSPID 2hctiwSPID
V022V332-V891NOFFO
*V032V342-V702* FFONO/FFO
V042V452-V612NONO
noitisoptluafeD*