Operating instructions

UPS Operating Instructions
6-10 Eaton 9E UPS (40–60 kVA, 208/220V) Generation 3 Installation and Operation Manual P-164000302—Rev 1 www.eaton.com/powerquality
Figure 6-7. Typical System Control Screen
Status:
Status:Status:
Status: Load
LoadLoad
Load Off
OffOff
Off
Load
LoadLoad
Load Off
OffOff
Off
Load
LoadLoad
Load Off
OffOff
Off
Normal
NormalNormal
Normal
Bypas s
Bypas sBypass
Bypas s
UPS
UPSUPS
UPS Battery
BatteryBattery
Battery UPM
UPMUPM
UPM
Dis able
Dis ableDis able
Dis able
Enable
EnableEnable
Enable
HE:
Table 6-4. Command Menu Operation
Function Subfunction Operation
UPS Control
Commands
Use the up or down arrow pushbutton to highlight the command function desired, then
press the RETURN pushbutton to execute the command or proceed to further command
screens.
Normal Mode Starts the UPS in High Efficiency (HE) Normal mode or transfers the UPS to HE Normal
mode from Bypass mode.
Bypass Mode Starts the UPS in Normal mode or transfers the UPS to Normal mode from Bypass mode.
High-Efficiency (HE) Mode Transfers the from HE Normal mode to Standard Normal mode.
Transfers the from Standard Normal mode to HE Normal mode.
Battery Control
Commands
Use the up or down arrow pushbutton to highlight the command function desired, then
press the RETURN pushbutton to execute the command.
Charger Turns the battery charger on.
Resting Turns the battery charger off.
Table 6-5. Typical System Status Messages
Function Message
UPS Load Off; Bypass; Online, HE
Bypass Off; On; Available
Charger Charger Resting; Charger