User manual

2 . Presentation
2.6 Display functions
Press the Enter ( ) button to activate the menu options . Use the two middle buttons ( and ) to scroll
through the menu structure . Press the Enter ( ) button to select an option . Press the button to cancel
or return to the previous menu.
Display information or Menu function
[Load] W VA A pf / [Input/Bypass] V Hz /
[Output/Efficiency] V Hz % / [Battery] % min V n° /
[DCbus] V / [Average power usage] Wh /
[Cumulat . power usage] Wh since date
Transfers the UPS on Bypass mode
Commands the load segments
Starts a manual battery test
Clears active fault
Returns all settings to original values
Clears average power usage measurement
Clears cumulated power usage measurement
Tests dry contact relay outputs
Sets product general parameters
Sets Output parameters
Sets On/Off conditions
Sets battery configuration
Selects faults, alarms and/or events to display
Displays the events stored
Clears events
Displays the faults stored
Clears faults
[Product type/model] / [Part/Serial number] / [UPS/NMC
firmware] / [Com card IPv4], [Com card IPv6], [Com card MAC] /
[Detected accessories]
Links to Eaton registration website
2.7 User settings
The following table displays the options that can be changed by the user.
Submenu Available settings
Language [English] [French] [German] [Spanish]
[Russian] [Portuguese] [Italian]
Menus, status, notices and alarms,
UPS fault, Event Log data and
settings are in all supported
Date/ time Format:
LCD Modify LCD screen brightness and
contrast to be adapted to room light
Audible alarm
[Enabled] [Disabled on battery] [Enabled]
[Always disabled]
Enable or disable the buzzer
Output voltage [200V] [208V] [220V] [230V] [240V] [230V]
Frequency converter:
[Enabled] [Disabled]
Frequency settable in frequency
converter mode
[Auto start delay]
[Auto shutdown delay]
[Industrial] [Network]
Set UPS behavior regarding transfer
on Bypass
Sets input voltage hysteresis
from 1 to 10V
[Enabled] [Disabled]
Power the output from Bypass
for high efficiency
Transfer if BP AC NOK
[Enabled] [Disabled]
Allow transfer on Bypass out
of tolerance
Main menu Submenu
Measurements
Control Go to Bypass
Load segments On/Of
f
Start battery test
Reset fault state
Restore factory set
Reset average power
Reset cumul . power
Dry contacts test
Settings Local settings
In/Out settings
On/Off settings
Battery settings
Event log Event filter
Event list
Reset event list
Fault log Fault list
Reset fault list
Identification
Register product
if an alarm occurs.
Output frequency
Load segments
Output mode
In/Out settings
Input volt hysteresis
High Efficiency
mode
Bypass transfer
5-6kVA EU_EN
conditions.
Disabled
Group1: [3s] Group2: [6s]
Group1: [Disabled]
Group2: [Disabled]
[Industrial]
[10V]
[Disabled]
[Enabled]
Page 1
3
[International] [US]
languages.
Default settings
[English]
User selectable when UPS is
powered for the first time.
[International]
Local settings