Technical information

134 Eaton RF-System - Help

In this case the direct measured value (0-100%) is sent to a dimming actuator or analog actuator.

An upper and lower limit can be set (if the measured value falls outside these limits, the limit value

is the maximum value sent) and the value can be inverted.

This setting can be used to control the brightness in a room as a function of external brightness,

for example….

2-fold remote control:

This device is a battery-powered sensor which can control all xComfort actuators (switching

actuator, dimming actuator, shutter actuator, etc.), but it can also send commands to the Home

Manager, Room Manager, etc. (e.g. to start complex processes).

The functions of this remote control are almost identical to a 2x button.

In the case of commands from the 2x remote control, we have to distinguish between the right and

left switch rocker.

The LED on the top left side shows when a command is sent (flashes briefly once) and when the

command has been acknowledged by the destination device (or the next device in the event of

routing) (flashes briefly twice). When the command has been successfully sent and acknowledged,

the LED then flashes three times.

Each rocker sends the following commands:

: short press on the button, top