Technical information

140 Eaton RF-System - Help

The name of each output can be freely defined or selected from a predefined list of names. Both

on the remote control and in the MRF it is possible to select which outputs should and which ones

should not be visible for operation.

If you press a key, the remote control will change from standby to operating mode and the display

will be switched on. When no further action is carried out, the remote control will switch to standby

mode again after a pre-defined time (default is 10 seconds).

All timers will of course continue to operate in standby mode.

Also refer to:

Remote Control with Display - Functions

Remote Control with Display - Timer

Remote Control with Display - Miscellaneous

Remote Control with Display - Functions:

This is where you can define the names and what to use for operating the assigned functions. You

can also see which actuators are assigned to the respective functions.

Also refer to chapter General Information on the Remote Control with Display