Technical information

149Eaton RF-System

connected.

If a sensor is occupied the device will send the command <SWITCHED ON>, if its not occupied it

will send the command <SWITCHED OFF>;

Configuration window:

Similar to a binary input in Mode 2 you can activate/deactivate cyclic sending for each channel and

set the cyclic time between 10 minutes and 18 hours.

Pendant remote control

The pendant remote control is a single channel remote control with the purpose of alarming in

case of emergency. It sends the same RF commands as a binary input in Mode 1 ( <ON

(Einzeltaste)>, <UP Press>, <UP RELEASE>)

Different to normal sensors the device will repeat a command more often if it will not be

acknowledged. So it has an improved transmission guarantee. Between the repeat of a command

lies a pause of 5 seconds.

The device is battery supplied can be assigned to every other xComfort device. (With the

exception of other sensors)

A LED on the upper left side of the device will indicate the actual state of the remote control. When

the key is pressed the LED will light until the command will be acknowledged by the receiver, blink

2 times and then deactivates.

If the command will not be acknowledged although it has already been repeated the LED will blink

5 seconds to indicate the failure.