Technical information

156 Eaton RF-System - Help

Assigned device:

In the stand alone operation there is no assigned device. Furthermore

the function „send own temperature to intelligent device“ is not used.

Request/Regulation time:

You can set the time that the device will compare the actual- and set-

temperature and if necessary does an adaption of the valve position

with this slider.

Offset of the measured

temperature:

You can set an offset temperature for the internal temperature sensor

of the device. That is necessary because eventually the temperature

measured near the radiator can be different than the temperature in

other areas of the room. So you can make sure that the thermostat will

regulate to the right temperature in the room and not just the

temperature near the radiator.

Frost protection:

You can set the temperature that is used for frost protection (7°C per

default).

The frost protection is active if the actual temperature falls below this

temperature. This is independent of other modes of the device and will

always work.

Open window detection:

If this function is activated the device will detect a temperature drop in

the room and switch off the radiator.

sing the slider you can change Using the slider you can change the sensibility (temperature drop within