Technical information

162 Eaton RF-System - Help
© 2013 Eaton Electrical Group
Help Network test
Help Network settings
Network test:
The network test can be used to check the LAN connection of all ECI’s in the project. All ECI’s
need to be fully configured and loaded completely and there must not be any double or invalid
IP-addresses. The test can be executed by using „Device Popup menu -> Network test“ of any ECI
in the project.
The ECI for that you execute this test needs to be in the RF reception area of the RF-Gateway.
Checking the mark for all existing entries you can choose to which other ECI’s you want to make
the network test. Clicking START will trigger a ping request from this ECI to all selected. While the
test is running the state of the respective ECI will be “pinging…”. The result will also be displayed
in the “State” column next to the name.
The network test can produce the following results::
Canceled! – There was no answer from this ECI and the test has timed out
Good connection – The connection to this ECI is good
Sufficient connection – The connection to this ECI is not perfect but still OK
Bad connection – The connection to this ECI is bad
Not reachable – This ECI could not be reached
See also Overview Ethernet CI
Network settings of the Ethernet CI:
Here you can find information about the possibilities for the ECI network settings. The network
settings can be reached by „Device Popup menu -> Network settings“.