Technical information

166 Eaton RF-System - Help

We recommend plugging the jumpers on the Multi-Heating actuator for each channel to „Heating

only“, “Cooling only” or “Heating and Cooling” depending on how you use the channels in the

Room-Manager. That will make sure that all channels are only controlled when their desired

operation type is active.

See also Heating and Cooling with the Room-Manager – Connection to a Multi-Heating actuator

Operation with the Home-Manager and other intelligent devices:

In this case every connected channel of the Multi-Heating actuator receives Set- and actual

temperature from its respective datapoint of a Home-Manager or other intelligent device. Each

datapoint can be connected to multiple inputs of the Multi-Heating actuator but each input can only

have one connection.

If an input of the Multi-Heating actuator is used for „Heating only“, „Cooling only“ or „Heating and

Cooling“ needs to be defined in the Configuration program of the Home-Manager or the 3rd Party

program for the intelligent device. Anyhow you need to make sure that the Multi-Heating actuator

and the control program in the intelligent device work in the same operation type at all time. This is

done by connecting a datapoint of the used device with the „Heating/Cooling“ input of the

Multi-Heating actuator. Every time the control program toggles between heating and cooling the

datapoint needs to send this information to the Multi-Heating actuator.