Technical information

171Eaton RF-System
© 2013 Eaton Electrical Group
definable minimum consuming power.
Each function (actuator, Binary input, Energy measurement) has its own configuration page in the
configuration window of the switching actuator. Additionally a general page will provide general
device information.
Channel overview:
The RF-channels of the new actuator are depending on the type (see function overview above).
However all types have at least one input channel for up to 32 different sensors and the output
channel of the new extended status message.
Type
Nr.
Name
Command/Value
possible connection
Input
0
Actuator
input
Commands of all binary
sensors
Connection of max. 32 binary sensor
channels
Output
0
Status
extended Status message
Connection will be automatically drawn as
a back channel if a new intelligent device is
connected to the actuator input channel.
See extended status message
Output
1
Output
Binary
input
M1: ON, ON pressed, ON
released; M2: ON, OFF;
all actuator inputs, Inputs Router, inputs of
intelligent devices,
Output
2
Energy
Energy value in X,XXXkWh
Room-Manager Energy input, all inputs of
intelligent devices, Inputs Router
Output
3
Power
active power in X.XW
Room-Manager Energy input, all inputs of
intelligent devices, Inputs Router
Output
4
Load error
YES=ON, NO=OFF
all actuator inputs, Inputs Router, inputs of
intelligent devices
Connection to other devices:
Using the connection mode connections to other device can be drawn. When drawing a
connection depending on the type of the connected device the right channel will automatically be
chosen. If not definite the channel can be selected from a popup window.
Configuration window – General:
In this window general information about the actuator is displayed and you have the possibility to
edit the device note.
In the area ‚Connections Output channels‘ all devices that are connected to each output channel
are listed.
In the area ‚device note‘ a description of the device with up to 255 characters is possible (same as
for the function Device note). This information will be saved in the project file.
In the area ‚Device information‘ all details about software- and Hardware-version are displayed.