Technical information

173Eaton RF-System

In the Tab ‚Switching actuator‘ all configuration possibilities for the actuator function can be set.

The different areas of configuration are as followed:

1. The left area displays the sensors assigned to the switching actuator. The types with binary

input will always have their internal input as first entry, but without function. By left-clicking one of

these sensors you can select the function you want to carry out. The possible functions are

depending on the type of the sensor resp. the RF-Commands of the sensor.

The different colored frames around the sensor symbols have the following meaning:

(only used for internal sensor): Depending on

the configuration state (red – no function configured, green – Function configured)

(only intelligent devices): Will be displayed for an

intelligent device that will receive the Status of the actuator (old Status message or new status

connection)

2. The next area (top center) depends on the sensor and displays the commands a sensor can

send to an actuator. They are depicted as icons, with the command buttons you can select from