Technical information

175Eaton RF-System
© 2013 Eaton Electrical Group
output action for Release Lock can be defined (ON, OFF, old value)
No Function
, occupies 1 command button
Has no Function, However the actuator will send a Resend of the RF-command if in a
group
Output-States of the Switching actuator:
A change between the different Switching-States of the Switching actuator will trigger a Status
Message to connected devices. Depending on the type of the intelligent device (old or new) the
Status message will be sent in the old format or in the new extended format (see extended status
message).
The following states are possible:
ON – the output is ON
OFF – the output is OFF
Blinking – the actuator is just executing a blink function, the output state cannot be definitely ON or
OFF as it changes over time
ON locked – The output is ON and any further operation by a normal switch function is not
possible at the moment (exception ‚Release Lock‘)
OFF locked – The output is OFF and any further operation by a normal switch function is not
possible at the moment (exception ‚Release Lock‘)
OFF over temperature – The output is OFF because the maximum internal temperature has been
exceeded. An operation that switches the output ON again is only possible if the internal
temperature falls below 15°C of the maximum value.
Functions for Pushbuttons, Remote control, intelligent devices and Binary inputs Mode 4:
On / Off (Standard)
ON / OFF, and free, only for selectable
On / Switch-on Delay
free selectable for , , and
Off / On with Switch-Off delay
free selectable for , , and
Off / Switch-off Delay
free selectable for , , and
Off with Advance Warning
free selectable for , , and
Push-button/Key Mode
for , or , ; only for oder selectable
Surge
only for and selectable
Blinking
free selectable for , , and
Activate Lock
free selectable for , , and
Release Lock
free selectable for , , and
Functions for Binary inputs Mode 1, Binary inputs Mode 3 (Pushbutton) and local inputs Mode 1:
Surge (Standard)
only for selectable
On / Switch-on Delay
free selectable for and
Off / On with Switch-Off delay
free selectable for and
Off / Switch-off Delay
free selectable for and
Off with Advance Warning
free selectable for and
Push-button/Key Mode
for and , only for selectable
Blinking
free selectable for and
Activate Lock
free selectable for and
Release Lock
free selectable for and
Functions for Binary input Mode 2 and 3 (Switch), Motion detector and local input Mode 2:
On / Off (Standard)
ON / OFF, only for selectable
On / Switch-on Delay
free selectable for and
Off / On with Switch-Off delay
free selectable for and
Off / Switch-off Delay
free selectable for and