Technical information

18 Eaton RF-System - Help

Here you can define the serial interface port (COM Port), where the Gateway is connected.

The quality requirement for the reception quality can also be configured („Allow connection only if

reception quality 'good' (recommended)”. This means only good connections can be calculated

successful (not medium quality connections). This raises the number of routing paths but

guaranties a safer transmission.

In the professional version you can determine the behaviour when drawing connections

1. Calculate immediately, error message if not successful (until now )

Like until now the connections is only drawn if the calculation is successful.

2. Calculate immediately, if not successful draw connection anyway

If the connections is drawn the system will try to calculate it immediately. When the calculation is

not successful the connection is drawn anyway but in red.

3. Don't calculate, draw connection immediately (independent from reception quality)

Every connection will be drawn immediately as red an uncalculated connection. You can manually

calculate such connection by clicking on it and “Calculate connection” or for the full project menu