Technical information

221Eaton RF-System

The device type of the scanned device and the actual name that can be changed (max. 21

characters) will be displayed in this window. If the scanned device is an actuator there will be the

possibility to operate the device using the

Identify

button (TOGGLE command will be sent).

Using the option “continue to execute this function for the next devices” you can chose if this

function will be executed for the next device again.

Using the

button will change the name of the device in the project and continue scanning

and using the

Skip

button will continue scanning without changing the device name.

Connection wizard

The function serves to create large group connections fast and without the manual drawing of

connections.

It is executed directly from the pop-up menu of a sensor using

Connection wizard...

. The chosen

sensor channel must be binary (on, off, too large, too small, etc.) so that the function can be

executed and only connections to actuators (switch actuator, dimming actuator, analogue actuator,

blinds actuator, routing actuator) are possible.

After the function is executed, the desired sensor channel must be selected (only for multi-channel

sensors).

After selecting the sensor channel and clicking on the OK button, you arrive at the main window of

the Connection Wizard.