Technical information

225Eaton RF-System

Yes

, you will be shown the new password once again. If

, you will be shown the old password

once again. In both cases, you will have the option of redefining the project password.

Password-protected devices were found:

If the current project password does not match the password in the scanned devices, you must

enter the correct password for all "blocked devices". These devices will then also receive the

current project password in MRF (the password will not yet be loaded, however).

With the option "Use as new password for all devices" (under the input field), you can assign the

password that you use to unblock a blocked device, to the entire project (like Define a Password).

This option is normally deactivated. If this option is activated and you now unblock devices with the

correct password, the entire project will be assigned this password.

If you have forgotten the password to one or more devices, you will have the option to reset them

using the

Forgot...

button, however you must have "On-Site Access" to the devices.

If this involves sensors, you must energise/activate them after pressing

Forgot...

–

the basic

settings will be loaded in the device and the password will be deleted.

With power-supplied actuators, you must reset them through the programming button (see Basic

Mode programming plan).

Home Managers and Room Managers can be reset through the Settings menu, and you can set

the communications interface to factory default settings, deleting the password in the process,

through the Homeputer Software by going to the menu items: "Configure -> Hardware interface...

-> Reset interface".

With Cancel, all locked devices are deleted from the screen, and you will only work with unlocked

devices, i.e. with those for which correct passwords have been entered.

Project-Password:

Define password:

You can define a password for the system under this menu item. Each device forming part of the

project, or which is to be scanned at a later date, will receive this password when loading

(password, changes or complete).