Technical information

46 Eaton RF-System - Help
© 2013 Eaton Electrical Group
Go Online
With this command you can set up a connection to the Gateway (RS232 interface or
USB-RF-Configuration-Stick).Usually this happens automatically when starting the program.
If you have connected the Gateway later or the connection has been cut, go to menu item
Gateway and select Connect to establish the connection.
Note: In the menu item Options you can select which interface (USB, COM1, COM2…) the
Gateway is connected to.
If more USB-RF-Configuration-Sticks are connected you will have the possibility to select the
desired one by its serial number.
Also see Gateway
Go Offline
Use this command to disconnect the Gateway.
Go to menu item Gateway and select Go off-line to disconnect the Gateway.
Also see Gateway
Identify
Use this command to identify the connected USB-RF-Configuration-Stick. The orange colored LED
on the device will blink for 10 seconds.
Software Update
Use this command to load a new software to the connected USB-RF-Configuration-Stick.
For more details see Software Update USB-RF-Sticks
Commands of the View Menu
The
View
menu includes the following commands:
Toolbar
Hides or displays the toolbar
Status Bar
Hides or displays the status bar
Project Topology
Shows or hides the Project Topology window
Background grafic
Shows or hides the background grafic
Group Frames
Shows or hides the group frames
Project-Notes
Shows or hides the project notes