Technical information

7Eaton RF-System

It is no longer possible to use datapoints of intelligent devices as outputs in the connection

wizard if they are already used as inputs

Changes in mains supplied sensors will now always be tracked immediately and

completely loaded to the devices with the ‚Load changes‘ function

Switching actuator 10A/16A will be supported for testing purpose, a new generation of

switching actuators with several new features and additional functions (expected release date Q1

2014)

New Router will be supported for testing purpose, a new generation of Routers (standard

and with Logic function – expected release date Q1 2014)

Function Barcode-Scan will be supported for testing purpose, a new function that can be

used to insert new devices to the project by scanning a Barcode situated on the device (planned

realization of the Barcodes on the devices Q1 2014)

Support of the Ethernet CI, USB-RF-Communication-Stick and Smart Home Controller

RF-Software Version 2.x for testing purpose, these versions are necessary to fully support the

extended Status message of the new Switching actuator generation

What’s new for 2.19?:

Added option to display the IP-address of a Smart Home Controller; executed by right click

on the device and selecting 'IP-address'

What’s new for 2.18?:

Smart Home Controller is supported, a new control and communication device that can be

accessed via Smartphone or Tablet (Device release date is planned for Q1 2013)

Fixes a rare issue that will prevent the USB-RF-configuration stick from losing its

RF-parameters and making it inoperative

Group connections that could not be calculated completely will no longer display a mixture

of red and black connections but only red (uncalculated) connections

Scanning an actuator will now correctly scan the manual routing flag in order to display the

different connection type correctly

Transfer virtual device functiuon and replace device will now correctly transfer all

Room-Manager shading settings

Saving the messages of the RF-monitor will again save the message data

RM-Software update: It is no longer possible to downgrade a Room-Manager with a

version greater than V39b to a lower version. Please always only use the actual Room-Manager

Version (V40a) that can be found in the MRF directory in the subfolder "Device

software\Room-Manager"

Virtual Room controllers used for Heating actuators will now be inserted with the right

mode (Send temperature value)

What’s new for 2.15?:

The actual device software of all devices that can be updated (Ethernet CI,

USB-RF-Kommunikationsstick, USB-RF-Konfigurationsstick, Room-Manager) are now located in

the subfolder "Device software" of the Eaton RF-System main folder.