Technical information

8 Eaton RF-System - Help

Multi-Heating actuator

will be supported, a new mains supplied device that can be used to

control electrical radiator valves

USB-RF-Configuration-Stick is supported, it’s the successor of the old RS232

configuration interface

USB-RF-Communication-Stick is supported, it has similar functionality as the old

USB-Communication interface

It is now possible to set Transmit- and Receive-performance of the new

USB-RF-Configuration-Stick in the options window

Room-Manager Software Version V40 is supported, this version is necessary to be able to

work with the new Multi-Heating actuator

Replace device: The old USB-Communication interface can now be replaced by the

Ethernet CI or the new USB-RF-Communication-Stick (this does not work backwards)

Connection „Send time and date when changing from X to Room-Manager“ now possible

for Home-Manager, USB-RF-Communication-Stick, USB-Communication-Interface and Ethernet

Window contacts and humidity sensor can now be connected to Room-Manager rooms

even if the room temperature is measured by a RF Radiator thermostat and Room-temperature of

that rooms can be used as variable for logic functions.

Deleting a connection of a group function will now set all remaining connections of that

group to „uncalculated“ instead of recalculating them (only if “Behavior when drawing connections”

is set to „Do not calculate, draw immediately“)

Room-Manager connections Actual values Room 1, Room temperature 1-6, Outdoor

temperature and Room humidity 1-6 now possible for Home-Manager,

USB-RF-Communication-Stick, USB-Communication-Interface and Ethernet CI

Room-Manager outputs can now be connected to Shutter actuators (Attention! Only ON

and OFF commands are sent, Settings need to be changed in the shutter actuator configuration

window)

After every scanning process the MRF will check if newly scanned devices have

connections to existing ones. If that’s the case these connections will only be drawn if the already

existing devices have valid entries for the connections. If not the connections will be automatically

deleted.

When copying a group of devices the switching function will now be correctly inserted

instead of using the standard configuration.

Replace device and Transfer virtual device functions will now correctly work for RF

radiator thermostats that already have connections to other devices

When scanning the reception quality it is no longer possible to cancel the process

prematurely if unknown password protected sensors are activated

When loading changes to selected devices or to devices of an area it is now possible to

toggle between mains and battery supplied devices

What’s new for 2.05:

RF Radiator Thermostat is supported, a new battery supplied radiator thermostat that is

used to regulate the Room temperature in combination with a Radiator

Ethernet CI is supported, a new device that connects the xComfort RF solution with the

Ethernet and adds various new functions and possibilities