Technical data

April 2008
PG03300001E For more information visit: www.eaton.com
16-31
Accessories & Modification Codes
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
Accessories
Lighting Contactors
Auxiliary Contacts for C30CN/ECC
A Mechanically Held Contactor with a 2-wire control module
uses 1NC auxiliary contact as standard for the control wiring
circuit. The Mechanically Held Contactor with a 3-wire con-
trol module uses 1NO-1NC auxiliary contacts as standard for
the control wiring circuit. See Table 16-90 for possible addi-
tional auxiliary contact configurations.
Table 16-90. Auxiliary Contact Configurations
Table 16-91. Auxiliary Contacts
Transient Suppressor Kits for CN35/ECL
10 – 60A Contactors
These kits limit high voltage
transients produced in the
control circuit when power is
removed from the contactor or
starter coil. There are three
separate suppressors for use
on 24 –120V, 240V or 480V
coils respectively.
These devices mount directly
to the coil terminals of light-
ing contactors 10 – 60A.
Table 16-92. Kits for 10 – 60A
100 – 300A Contactors
This device mounts on top of
any side mounted auxiliary
contact on lighting contactors
100 – 300A. It connects across
coil terminals on any 120V
contactor magnet coil.
Limits high voltage tran-
sients produced in the circuit
when power is removed from
the coil.
Table 16-93. Kits for 100 – 300A
2-Wire 3-Wire
None
1NO (single-pole)
2NO (double-pole)
1NC (double-pole)
1NO-1NC (NO single pole, NC double-pole)
2NO-1NC (double-pole)
1NC (double-pole)
1NO (double-pole)
1NO-1NC (double-pole)
Auxiliary Block Catalog
Number
Single-Pole C320AMH1
Double-Pole C320AMH2
Auxiliary Contacts
Description Coil Voltage Catalog Number
Transient Suppressor 24 –120V
240V
480V
C320TS1
C320TS2
C320TS3
Description Coil Voltage Catalog Number
Transient Suppressor 120V C320AS1
Cat. No. C320TS2
Cat. No. C320TS2