Technical data

April 2008
16-42
For more information visit: www.eaton.com PG03300001E
Accessories & Modification Codes
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
16
Modification Codes
Table 16-133. D — Device Labels, Deceleration Relay,
Drain and Breather, Duplex Modifications

Not available for IT. or XT Starters.
Table 16-134. E — Enclosure Modifications, Elapsed Time Meter,
Duplex Outlet, Enclosure for Starter, Enclosure Clear Cover, Enclosure
Material

Not available for IT. or XT Starters.
Table 16-135. F — Fuse Clips, Fuse Blocks, Fungus Protection,
Fingerproof Covers, EMI Filter

The EMI filter is not necessary to meet the CE mark requirements for
EMC when installing the MVX in an EC country.

Not available for XT Starters.
Modification Catalog
Number
Suffix
Description
Device Labels D1 (Each Label)
Decel. Relay

D2 2-Speed
Drain and
Breather
(Type 7/9
Enclosure)

D5 Drain and Breather
D6 Drain Only
D7 Breather Only
Duplex
Modifications
D12 Alternator Omitted (Deduct Price)
D14 START/STOP Pushbuttons — Supplied for
Each Motor
D15 HAND/OFF/AUTO Selector Switch —
Supplied for Each Motor
D16 No. 1 Lead - No. 2 Lead Selector Switch for
Manual Selection of Lead Pump (Alternator
is Omitted)
D17 Red RUN Pilot Light — Supplied for Each
Motor
D18 Push-to-Test Red RUN Pilot Light — Supplied
for Each Motor
D19 TEST Pushbutton for Each Motor
D20 CPT, 120V Secondary, 2 Pri. Fuses & 1 Sec.
Fuse — Supplied for Ea. Motor
D21 CPT w/100VA Extra Capacity, 120V Sec.,
2 Pri. Fuses & 1 Sec. Fuse — Supplied for
Each Motor
D22 CPT w/200VA Extra Capacity, 120V Sec.,
2 Pri. Fuses & 1 Sec. Fuse — Supplied for
Each Motor
D23 CPT for Duplex — Order by Description
D24 Add 2 Relays to Modify Controller to Operate
w/Single-Pole Pilot Devices
D25 Add 3 Relays to Modify Controller to Operate
w/Single-Pole Pilot Devices
D26 Green — OFF for each starter
D27 Green — Push-to-Test OFF for ea. starter
Modification Catalog
Number
Suffix
Description
Enclosure
Modifications
E3 Oversize Enclosure
E4 Enclosure — Order by Description
E8 Service Entrance Rating w/Ground Bar
E11 Safety Door Interlock
Elapsed Time
Meter
E9 Wired Across Coil, Type 1, 12
Wired Across Coil, Type 3R, 4X
E10 Elapsed Time Meter — Order by Description
Duplex Outlet E12 Convenience Duplex Outlet Mounted in Side
of Enclosure
Enclosure for
Starter

E13 Horizontal Combination Starter, Size 0 – 2
E14 Narrow Combination Starter, Size 0 – 2
Enclosure Clear
Cover for XT
E19 Clear Cover for Halyester Enclosure
Nonmetallic
Enclosure
Material
E20 Convert to 316 Stainless Steel
E21 Convert from Type 3R to Stainless Steel
Modification Catalog
Number
Suffix
Description
Fuse Clips

F1 Change Fuse Clips in Position 8 to Class J
F2 Change Fuse Clips in Position 8 to Class H
& K (30 & 60 Ampere Only)
Fuse Blocks F4 Power Fuses Included — Order by
Description
F5 30 Ampere Control Circuit Fuseholder (KTK)
Mounted on Panel (Unwired), Fuse Not
Supplied
F6 30 Ampere Control Circuit Fuseholder
Mounted on Panel (Unwired), FNQR Fuse
Supplied
F7 3-Pole Power Fuseholder Mounted on Front
Contactor
F8 Separate Fusing of Control Power
Supply — IT.
F10 Blown Fuse Indicator (Not for PFC)
F21 Class CC Fuses
EMI Filter
(MVX)
F22 3-Phase

F23 1-Phase
