Firmware Manual

Chapter 5—Standard Application
PowerXL DG1 Series Adjustable Frequency Drives MN040004EN—March 2014 www.eaton.com 33
Notes
1
Parameter value can only be changed after the drive has stopped.
2
Parameter value will be set to be default when changing macros.
M42 Last Active Fault 0 28 0 = Null
1 = Over Current
2 = Over Voltage
3 = Earth Fault
4 = Charging Switch
5 = Emergency Stop
6 = Saturation Trip
7 = System Fault
8 = Undervoltage
9 = Input Phase Superv
10 = Output Phase Superv
11 = Brake Chopper Superv
12 = Drive Under Temp
13 = Drive Over Temp
14 = Motor Stalled
15 = Motor Over Temp
16 = Motor Under Load
17 = IP Address Conflict
18 = Power Board EEPROM Fault
19 = FRAM Fault
20 = S-Flash Fault
21 = MCU Watchdog Fault
22 = Start-up Prevent
23 = Thermistor Fault
24 = Fan Cooling
25 = Compatibility Fault
26 = Device Change
27 = Device Added
28 = Device Removed
29 = Device Unknown
30 = IGBT Over Temp
31 = Encoder Fault
32 = AI < 4 mA (4to20 mA)
33 = External Fault
34 = Keypad Comm Fault
35 = Fieldbus Fault
36 = Option Card Fault
37 = Bypass Overload
38 = Realtime Clock Fault
39 = PT100 Fault
40 = Motor ID Fault
41 = Current Measure Fault
42 = Power Wiring Error
43 = Control Board Overtemp
44 = Internal Control Supply
45 = Speed Search Fault
46 = Current Unbalance
47 = Replace Battery
48 = Replace Fan
49 = Safety Torque Off
50 = Current Limit Controller
51 = Over Voltage Controller
M43 RTC Battery Status 583 0 = Not Installed
1 = Installed
2 = Change Battery
3 = Over Voltage
M44 Instance Motor Power kW 0.00 1686
M45 Energy Savings Varies 2119
M46 Multi-Monitoring 1, 2, 3 30
Table 14. Monitor—M, continued
Code Parameter Min. Max. Unit Default ID Note