Cut Sheet

V8-T9-4 Volume 8—Sensing Solutions CA08100010E—November 2012 www.eaton.com
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9
9.1
Fiber Optic Cables
Plastic Fiber Optic Cables
Accessories
Cable Accessories
Bulk Fiber Optic Cable Accessories
Lenses
For 1 mm diameter bulk cable only. Lenses extend the range of thru-beam sensors.
Sold individually—two required for thru-beam sensing.
Lenses
Technical Data and Specifications
Plastic Fiber Optic Cables
Note
1
IMPORTANT: Do not bend fibers within 0.5 in of either end.
Description Range Increase Catalog Number
Fiber Optic Cable Cutter
For 1 mm diameter fiber, good for six cuts — 8909A-6501
Fiber Optic Termination
For mounting of 1 mm diameter bulk fiber. Sensing distance is the
same as for bare fibers without lenses
— 6230A-6503
Dimensions, see Page V8-T9-6.
Description Range Increase Catalog Number
Thru-Beam Lenses
0.25 in diameter thru-beam lens 10X 6230A-6505
0.5 in diameter thru-beam lens 100X 6230A-6509
1.0 in diameter thru-beam lens 200X 6230A-6508
Dimensions, see Page V8-T9-6.
Description
Specification
Storage and operating temperature –22° to 158°F (–30° to 70°C)
Length, pre-assembled cables 6.6 ft (2m)
Sheathing Polyethylene
Bend radius
1
1 mm fiber: 2 in; 0.5 mm fiber: 1 in with no loss of optical signal.
Tighter bends will result in some signal loss.
Fiber Optic Termination
0.25 In Diameter
Thru-Beam Lens
0.5 In Diameter
Thru-Beam Lens
1.0 In Diameter
Thru-Beam Lens