User`s guide

Switched ePDU Initial Configuration
Eaton
®
User's Guide for Basic, Monitored, and Switched ePDUt S 164202115 Rev 1
28
About 15 seconds after power is applied to the Switched ePDU, the Switched
ePDU's network and hardware parameters display for approximately 5 seconds.
The Switched ePDU then completes its initialization and displays a login prompt,
similar to the following sample of boot text:
Bootloader Version 1.0.B
− Decompressing Image into RAM, please wait...
Eaton Corporation
Data Center Solutions − Eaton
Support and Sales:
Call: (800)356−5737
Email: [e-mail]
NET+WORKS Version 6.0
PLATFORM: ePDU3600
APPLICATION: Eaton Switched ePDU Firmware 2.0.H
−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−
NETWORK INTERFACE PARAMETERS:
IP address on LAN is 192.168.168.168
LAN interface’s subnet mask is 255.255.255.0
IP address of default gateway to other networks is 192.168.168.1
HARDWARE PARAMETERS: Serial channels will use a baud rate of 9600
This board’s MAC Address is 00:04:F3:00:06:35
After board is reset, start−up code will wait 5 seconds
Default duplex setting for Ethernet connection: Half Duplex
The unit is configured for 16 outlets.
Resetting system defaults: No
Strapping ID: 0
−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−
FS−FORTH NVRAM Format. START_OF_FREE_NVRAM=0x140
Press any key in 5 seconds to change these settings.
Loading Data from NVRAM.
Com1 Online at 8,N,1,None 9600 Baud.
Current time and date:
Date: 05/23/2008
Time: 10:00
Standard Web Server Started on Port 80.
Telnet Services started on Port 23.
SNMP Services started on Port 161.
Email Services Started − Mail Server:0.0.0.0.
Eaton Switched ePDU Login
Enter UserName: