User`s guide

Switched ePDU Admin Using Serial or Telnet
Eaton
®
User's Guide for Basic, Monitored, and Switched ePDUt S 164202115 Rev 1
61
Eaton Corporation
Power Distribution and Remote Management
Support and Sales:
Call: 1−800−843−9433
Email: [e-mail]
NET+WORKS Version 6.0
PLATFORM: ePDU3600
APPLICATION: Eaton FTP Server Application 1.0.1
−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−
NETWORK INTERFACE PARAMETERS:
IP address on LAN is 192.168.168.168
LAN interface’s subnet mask is 255.255.255.0
IP address of default gateway to other networks is 192.9.200.254
HARDWARE PARAMETERS:
Serial channels will use a baud rate of 9600
This board’s MAC Address is 00:04:F3:00:06:35
After board is reset, start−up code will wait 5 seconds
Default duplex setting for Ethernet connection: Half Duplex
−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−
NVRAM Format. START_OF_FREE_NVRAM=0x140
Press any key in 5 seconds to change these settings.
Eaton FTP Server ready.
At this point the FTP server is ready to receive the firmware upgrade. Using an FTP
program, such as FTP Commander or the command line FTP program available with
Microsoft Windows, connect to the Switched ePDU's IP address (port 21) with the
Admin username and password (default is ipc), upload the image.bin file, and
disconnect from the Switched ePDU. Once the FTP connection has been
disconnected, the FTP server automatically reboots the Switched ePDU into the
upgraded software application.
NOTE To ensure proper Switched ePDU operation of the upgraded application software, set the system
defaults after upgrading the firmware. Select Set System Defaults under the Administrative Utilities menu.
Show Firmware Version
Selecting this menu option displays the current application firmware version.
Set System Defaults
To reset a Switched ePDU to its factory-default settings, select this menu option and
follow the prompts.