Cut Sheet

V10-T15-42 Volume 10—Enclosed Control CA08100012E—June 2015 www.eaton.com
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15.2
Accessories and Modification Codes
Modification Codes
C—Control Power Transformer, IT. Power Supplies, Control Relays, Cover Control (not elsewhere
defined), Current Transformers, Compelling Relay, Control Wiring, Control Circuit Breaker,
Separate Control, Customer-Supplied Components, Contactors, Counter, E-Stop Relay, DC/AC
Interface, Separate Source Disconnect, Bypass Contactors, continued
D—Device Labels, Deceleration Relay, Drain and Breather, Duplex Modifications
Note
1
Not available for XT starters.
Modification Description
Catalog Number
Suffix
Contactor/starter Contactor/starter—order by description C40
Counter Operations counter C41
E-stop relay E-stop relay (DeviceNet) C43
DC/AC interface DC/AC interface module C44
1
Separate source disconnect IEC separate source disconnect for control circuitry C45
Bypass contactors for IT. RVSS Isolation contactor C46/J1
Output contactor C46/J2
Bypass contactor C46/J3
Isolation/output/bypass contactor C46/J4
Modification Description
Catalog Number
Suffix
Device labels (Each label) D1
Decel. relay
1
Two-speed D2
Drain and breather
(Type 7/9 enclosure)
1
Drain and breather D5
Drain only D6
Breather only D7
Duplex modifications Alternator omitted (deduct price) D12
START/STOP pushbuttons—supplied for each motor D14
HAND/OFF/AUTO selector switch—supplied for each motor D15
No. 1 lead–No. 2 lead selector switch for manual selection of lead pump
(alternator is omitted)
D16
Red RUN pilot light—supplied for each motor D17
Push-to-test red RUN pilot light—supplied for each motor D18
TEST pushbutton for each motor D19
CPT, 120V secondary, two primary fuses and one secondary fuse—
supplied for each motor
D20
CPT with 100VA extra capacity, 120V secondary, two primary fuses and one
secondary fuse—supplied for each motor
D21
CPT with 200VA extra capacity, 120V secondary, two primary fuses and one
secondary fuse—supplied for each motor
D22
CPT for duplex—order by description D23
Add two relays to modify controller to operate with single-pole pilot devices D24
Add three relays to modify controller to operate with single-pole pilot devices D25
Green—OFF for each starter D26
Green—push-to-test OFF for each starter D27
Green—RUN light (duplex pump) D28
Red—STOP light (duplex pump) D29
P-T-T—green RUN light (duplex pump) D30
P-T-T—red STOP light (duplex pump) D31
Elapsed time meter (duplex pump) D32