Cut Sheet

V10-T15-14 Volume 10—Enclosed Control CA08100012E—June 2015 www.eaton.com
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15
15.1
Accessories and Modification Codes
Accessories
DC/AC Interface Module
The catalog number C320DC
Interface Module is an
optically isolated solid-state
switch which provides a
means of operating AC coils
with 5–48 Vdc control signal.
It acts as a space saving
interposing relay which can
switch a specified 50/60 Hz
AC source to the contactor or
starter coil.
The module may be directly
attached to the coil terminals
of any Freedom Series
contactor or starter—NEMA
Sizes 00–3 and lighting
contactors 10–100A. It also
has provisions for DIN rail
mounting.
The module will operate coils
within the voltage ranges
shown in the table below.
Design Characteristics
●
DC Input: 5–48 Vdc at mA
nominal
●
AC operating voltage:
240 Vac (360 VA) ±10% 50/
60 Hz
●
DC operating voltage:
30 Vdc maximum (0.5A)
●
AC current rating
●
10A make (inrush)
●
1A break (sealed)
Controller Coil Voltage Ranges
Typical Application
Product Selection
Controller Catalog
Number Prefix
Controller
Size or Rating
Coil Range
Volts AC
AN16, AN56, CN15, CN55 00–0 24–240
1–2 48–240
3 110–240
CN35 10–30A 24–240
60A 48–240
100A 110–240
Coil Voltage Catalog Number
5 Vdc C320DC2V5
6 Vdc C320DC2V6
9 Vdc C320DC2V9
12 Vdc C320DC2V12
48 Vdc C320DC2V48
24 Vdc Input
Observe
Polarity
on Module
24–240 Vac
50/60 Hz
Contactor Coil
Solid-State Switch
DC/AC Interface
Module
Finger Protection Shields
Snap-on shields for both
contactors and starters
provide Type IP20 finger
protection. Prevents
accidental contact with line/
load terminals.
Product Selection
Adapter to DIN Rail Mount
NEMA 1–2 Contactors
Designed to allow DIN rail
mounting of NEMA 1–2
contactors. Includes
all hardware required to
convert contactors from
panel mounting to 35 mm
DIN rail mounting.
Product Selection
Adhesive Dust Cover
NEMA Sizes 00–2
These adhesive stickers
come 25 to a package and
provide extra protection
from
contaminants when applied to
the
sides of Freedom NEMA
Sizes 00–2.
Adhesive covers are easily
applied to side opening
where auxiliaries are not
installed and provide extra
protection from metal filings
and other debris.
Product Selection
Application Catalog Number
NEMA Size 00 C320LS1
NEMA Size 0 C320LS2
NEMA Sizes 1–2
Contactors C320LS3
Reversing contactors C320LS4
NEMA Size 1
Starters C320LS5
Reversing starters C320LS6
NEMA Size 2
Starters C320LS7
Reversing starters C320LS8
Description
Catalog
Number
Adapter to DIN rail mount C320DN65
Description Catalog Number
25 to a package C320DSTCVR