Instruction Leaflet IL 29C101I Effective December 2013 Supersedes IL 29C101H Dated 1/11 Installation Instructions for EHD, EDB, EDS, ED, EDH, EDC, FDB, FD, HFD, FDC, HFDDC Circuit Breakers and Molded Case Switches Contents Description Page Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Manual Operation . . . . . . . . . . . . . . . . . . . . . . . . . 4 Inspection and Field Testing . . . . . . . . .
Instruction Leaflet IL 29C102I Effective December 2013 WARNING DO NOT ATTEMPT TO INSTALL OR PERFORM MAINTENANCE ON EQUIPMENT WHILE IT IS ENERGIZED. DEATH, SEVERE PERSONAL INJURY OR SUBSTANTIAL PROPERTY DAMAGE CAN RESULT FROM CONTACT WITH ENERGIZED EQUIPMENT. ALWAYS VERIFY THAT NO VOLTAGE IS PRESENT BEFORE PROCEEDING WITH THE TASK, AND ALWAYS FOLLOW GENERALLY ACCEPTED SAFETY PROCEDURES. EATON IS NOT LIABLE FOR THE MISAPPLICATION OR MISINSTALLATION OF ITS PRODUCTS.
Instruction Leaflet IL 29C101I Installation Instructions for EHD, EDB, EDS, ED, EDH, EDC, FDB, FD, HFD, FDC, HFDDC Circuit Breakers and Molded Case Switches Line End 1 Pole 2 Pole 4 Pole 3 Pole 4.500 4.500 (114.30) (114.30) .688 (17.46) 2-6. If required, install terminal shield on circuit breaker cover with mounting screws provided. 2-7. If required, install an interphase barrier by sliding barrier into dovetail grooves between terminals. .75.750 (19.05) (19.05) 2.875 (73.
Instruction Leaflet IL 29C101I Installation Instructions for EHD, EDB, EDS, ED, EDH, EDC, FDB, FD, HFD, FDC, HFDDC Circuit Breakers and Molded Case Switches Effective December 2013 3. Manual Operation 4. Inspection and Field Testing Manual operation of the circuit breaker is controlled by the circuit breaker handle and the PUSH-TO-TRIP button. The circuit breaker handle has three indicated positions, two of which are shown on the cover with raised lettering to indicate ON and OFF.
Installation Instructions for EHD, EDB, EDS, ED, EDH, EDC, FDB, FD, HFD, FDC, HFDDC Circuit Breakers and Molded Case Switches Instruction Leaflet IL 29C101I Effective December 2013 5. HFDDC 5-1. The HFDDC circuit breakers and switches are qualified for direct current voltages and interruptions with multiple poles wired in series. 5-2. See Figures 5, 6, 7, and 8 for typical wiring configurations. A 3-pole breaker may be wired as a 2-pole. 5-3.
Instruction Leaflet IL 29C101I Effective December 2013 Installation Instructions for EHD, EDB, EDS, ED, EDH, EDC, FDB, FD, HFD, FDC, HFDDC Circuit Breakers and Molded Case Switches The instructions for installation, testing, maintenance, or repair herein are provided for the use of the product in general commercial applications and may not be appropriate for use in nuclear applications.
