Cutler-Hammer Fareo® 15808 1.L. 156068 Part No.6648C76H03 File 29-000 Instructions for Drilling and Assembling Fie Shaft™ Handle Mechanism for L, M, MDL, N, and R Frame Series C Circuit Breakers, Molded Case Switches, and Chimps AA WARNING DO NOT ATTEMPT TO INSTALL OR PERFORM MAINTENANCE ON EQUIPMENT WHILE IT IS ENERGIZED. SEVERE PERSONAL INJURY, DEATH OR SUBSTANTIAL PROPERTY DAMAGE CAN RESULT FROM CONTACT WITH ENERGIZED EQUIPMENT. ALWAYS VERIFY THAT NO VOLTAGE IS PRESENT BEFORE PROCEEDING WITH THE TASK.
Page LL. 166068 Lo LEAF Buk HL BT LES SHAY HHS TIG Wi LDA rd Occasion 1708 405 SCREE Ls HEAD BUTS FLL SIFT TETRA SLATE ASSIGN No nif Erosion | Ay Fare CR B66 READ KTS, Std Ab s1 185 NTS LM ANGLE EXPENSE 16% wo NG EEE LH. FRE tarn HANDLE EXTENSION" wri sd ZR K2 FRA Fig.
LL. 156068 INSTALLATION 1. Remove the two x 5/8" screws and lock washers from the outer handle mechanism. Place each screw and lock washer though the pivot bracket assembly. Thread the retaining washers enclosed in the parts kit onto the x 5/8" screws. See Figure 1-1, 2. Connect the actuator link from the outer handle mechanism on the pivot bracket assembly. Mount the pivot bracket assembly to the enclosure and outer handle mechanism by securing the mounting hardware.
Page 1.L. 156068 Situation: Breaker Resets after tripping, but does not turn ON. Adjustment: Loosen the adjusting nut that is located on the end of the shaft and turn towards the end of the shaft about 1/5-2 wens. Re-tighten the adjusting nut that is closest to the black cap to the handle extension and the outing adjusting nut. Recheck for the ON, OFF, and RESET position.
LL.
Page LL. 156058 Cutler-Hammer Pittsburgh, Pennsylvania U.S.A.