User Manual

Temperature Sensor
IM00416015E
Part No.: 68B5040H11
© 2008 Eaton Corporation
• Kitchen
• Cellar
• Bathroom
• Tool Shed
• Loft
• Storage Area
• Bedroom
• Attic
• Basement
• Living Room
• Office
• Garage
Temperature Sensor Uses:
Temperature Sensor Components
Home Key
™
Slide Channel
Antenna
Attach enclosed
adhesive on
back for placement
FCC Statement
(Compliance Statement, Part 15.19): This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
WARNING (Part 15.21): Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
To comply with FCC’s RF exposure limits for general population/uncontrolled
exposure, the antenna(s) used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located
or operating in conjunction with any other antenna or transmitter.
Industry Canada Statement
The term “IC” before the certification/registration number only signifies that the
Industry Canada technical specifications were met.
Interference
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, then the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into a power source on different circuit than the receiver.
Sensor Maintenance and Battery Replacement
Cleaning the sensor
Clean with a soft, dry cloth.
To check sensor battery level
Using the Home Key, highlight the sensor icon. Click the thumbwheel once and
note the battery status on the bottom line of the screen.
To check if sensor battery is low or depleted
When sensor battery is low, a flashing low battery icon appears on the Home Key
above the sensor icon, and the screen is amber in color. When a battery is
depleted, a question mark will appear above sensor icon.
Replacing a depleted battery
Remove the depleted battery and replace with one lithium CR123A 3V battery,
available through the Internet and anywhere camera and camcorder supplies
are sold.