User Manual

Need help? Call 1-800-813-2199 for customer support or visit www.homeheartbeat.com
If Your Temp Sensor . . .
• will not respond, make sure the battery in the sensor is installed correctly.
• does not send a signal to the Base Station, move the sensor and Base Station closer together (or consider getting a Home Heartbeat Range
™
Extender).
Set up
Test
If the Home Key or sensor is out of range, you can:
• Add a Home Heartbeat
™ Range Extender between the Base
Station and Sensor, or
• Select an alternate location for the Sensor, or
• Try moving the Base Station to a more central location in your home.
Then, complete Step 1 again.
Temperature Sensor
CARRY the sensor, battery, and the
Home Key to the location where you
want to place it.
OPEN the sensor cover and insert
the battery. The green LED light inside
the sensor should flash four times if the
battery is good. Close the cover.
CLICK the Home Key thumbwheel to
wake the screen, and SLIDE the Home
Key into the Slide Channel on the top
of the sensor. The Home Key screen
should say:
Please wait…
Device found
OK to remove Key.
Follow the instructions on the Home Key screen to join the sensor to the
system, name it, and set In-Home Awareness and "CallMe"
Awareness. After options are set and you click Done, go
back?, the Home Key screen will indicate that the sensor is joined to the
system. You may go to Step 2.
If you slide the Home Key into the sensor Slide Channel and the Home Key
screen shows either of the following messages, it means that the Home Key
or sensor may be outside the range of the Base Station.
Device found
OK to remove Key...
ROLL OVER and highlight the Temperature
Sensor icon on the Home Key.
The initial temperature threshold of your
Temperature Sensor is set at 40° F. Check that
the sensor reports 'Above temp' on the
Home Key at room temperature.
DOUBLE-CLICK the Home Key thumbwheel
on the Temperature Sensor icon to reveal
the control menu. Use the 'Change
threshold?' option to set a new temperature threshold above room
temperature, e.g. 100° F.
Slide the Home Key into the Slide
Channel of the Temperature Sensor.
If the Home Keyis not out of range,
the new threshold setting will now
be registered with the sensor.
Check that at room temperature the sensor reports 'Below temp' on the
Home Key for the 100° F threshold setting.
Remove Key...
Please try again
Sensor out of range?
Remove Key...
Can't set up now
Key out of range
Temp Sensor
Above temp for 5 secs
Temp Sensor
Below temp for 5 secs
Place and use
MOUNT the Temperature Sensor in the
measurement location by attaching the
enclosed adhesive tape on the back .*
Set the required temperature threshold using
the Home Key, following the procedure described in the test. If you
would like an immediate temperature threshold update, slide Home Key
into the sensor Slide Channel. Otherwise, please allow up to one hour
for the new settings to take effect.
* Be sure that the area of installation is
clean and dry.