Cutler-Hammer Ver I.L. 29C401H Installation Instructions for Series C F-Frame Motor Circuit Protector Type HMM & CHIMPS A WARNING DO NOT ATTEMPT TO INSTALL OR PERFORM MAINTENANCE ON EQUIPMENT WHILE IT IS ENERGIZED, DEATH, SEVERE PERSONAL INJURY, OR SUBSTANTIAL PROPERTY DAMAGE CAN RESULT FROM CONTACT WITH ENERGIZED EQUIPMENT, ALWAYS VERIFY THAT NO VOLTAGE IS PRESENT BEFORE PROCEEDING WITH THE TASK, AND ALWAYS FOL LOW GENERALLY ACCEPTED SAFETY PROCEDURES.
Page 2 1.L. 29CG401H 2. INSTALLATION The installation procedure consists of inspecting and mounting the MCP, connecting and torquing the line and load terminations, and attaching terminal shields or barriers, when required. To install the MCP, perform the following steps: F-Frame M Cps are factory sealed. UL489 requires that internal accessories be installed at the factory. Where local codes and standards permit and UL component recognition is not required, internal accessories can be field installed.
I.L. 29C401H Page 3 TABLE 2-1. TERMINAL TYPES Terminal Terminal Screw AWG Mote Wire Tagus Value Catalog Number Head Wie Wie Type Lb in (Nem) Material Type Range Range ATAZSFDY Aluminum 16 #0 2505 Cu Al 120 I38 | International 5 Socket ’ "Symbol (OFF) Hex Han die Position STAZZSFDMIY Aluminum mm $4.40 25.95 Cw Al 120 (13.8) anarchic Color Racket Red ON White TRIP 3TA226FDK(NE Aluminum S16 #5300 16.
Page 4 1.L. 29C401H TABLE 3-1: MCP TRIP SETTINGS TABLE 3-1: MCP TRIP SETTINGS (CONTINUED) Cam Typical Motor NAME Contain. MCP MCP Cam Typical Motor NAME Continuum MCP Set. Full Loud Current Starter yous Catalog Trip Set Full Load Current Starter yous Catalog Trp 9 amperes Size Amps Number Saving 8 Amporea® Size Amps Number Skiing A161. 214 210 215 268 280 cor.
I.L. 29C401H Page TABLE 3-2: SPECIAL APPLICATION MCP TRIP SETTINGS Cam Setting MCF MCP Catalog Trip Number Setting® Continuous Ampere Rating 40 43 46 HMCP025D0 49 52 585 58 80 256A 80 87 83 HMCPO50G2 88 103 108 116 120 5A 115 122 130 HMCPO7042 139 145 183 160 170 70A 160 174 185 HMCP100L3 186 207 218 229 240 100A IOTMUOBINIODITMTOIRIOTMOOTHNID "MOOT > @ Gator FLA ranges are typical. The corresponding trip setting is 13 times the FLA value shown.
Page 6 I.L. 29C401H 4-5. Check terminals and connectors for looseness or 4-6. Check MCP mounting hardware; tighten if consignees af overheating. Overheating will show as dispensary. coloration, meting, or blistering of conductor insulation son, or as pitting % melting oo variances 4-7. Check area where MCP is installed for any safety due to arcing. If there is no evidence of overheating hazards including personal safety and fire hazards.
