Installation Manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2: Overview and Specifications
- 3 Mechanical Installation
- 4 Electrical Installation
- 5 Communication Installation
- 6 Using the IQ 250/260
- Introduction
- Understanding Meter Face Elements
- Understanding Meter Face Buttons
- Using the Front Panel
- Understanding Startup and Default Displays
- Using the Main Menu
- Using Reset Mode
- Entering a Password
- Using Configuration Mode
- Using Operating Mode
- Understanding the % of Load Bar
- Performing Watt-Hour Accuracy Testing
- 7 Using the I/O Option Cards
- 8 Programming the IQ 250/260
- Overview
- Connecting to the IQ 250/260
- Accessing the IQ 250/260 Device Profile
- Performing Tasks
- Configuring Settings
- Configuring I/O Option Cards
- Polling the IQ 250/260 Meter
- Using the Tools Menu
- Performing Additional Software Tasks
- Appendix A Navigation Maps
- Appendix B Modbus Map
- Appendic C Using DNP Mapping
Chapter 8:
IQ 250/260 Meter Programming the IQ 250/260
www.eaton.com IB02601006E 8-39
Resetting Device Information
1. Click Tools>Reset Device Information. You will see the screen shown
on the right.
2. Select the items you want to reset and click Reset.
NOTES:
• You can reset Max/Min Blocks, Energy Accumulators, and Option Card
Accumulators.
• When installing a Pulse Output/Digital Input card or a Relay Output/Digital
Input card, we recommend you reset the accumulators for the card, in order
to prevent erroneous counts.
• This feature requires a Password if Password for Reset is enabled for the
meter.
Retrieving Device Status
1. Click Tools>Retrieve Device Status. you will see the screen
shown on the right.
NOTE: This is the same screen that opens when you rst c
onnect to the meter.
2. This screen shows the status of any connected devices. If
more than one meter is displayed, click on a device to display
detailed information for it on the right side of the scren.
3. Click OK to close the screen.
Viewing Option Card Information
1. Click Tools>Option Card
Information. You will see the
screen shown on the right.
This screen displays detailed
information about any Option
cards installed in the meter:
• Type
• Sub Type
• Card Name
• Serial Number
• Version
• Test Information.
2. Click Close to close the screen.