Cut Sheet

Volume 7—Logic Control, Operator Interface and Connectivity Solutions CA08100008E—June 2015 www.eaton.com V7-T1-217
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1.8
Pushbuttons and Indicating Lights
30.5 mm Heavy-Duty Watertight/Oiltight—10250T
Four-Position Joystick Operators
The joystick operated control
unit is intended for AC
application only. For other
use, see Application
Caution on preceding page.
The panel area required for
the four-position operator is
equivalent to two standard
pushbutton operators.
The latch holds the lever in
the center position. The
trigger latch must be released
before lever can moved into
any position.
Four-Position Joystick Operators—UL (NEMA) Type 3, 3R, 4, 4X, 12, 13
Field Conversion—Gate
The factory assembled four-
position operator is
assembled with a gate
arranged for four handle
positions.
Handle Positions
Three additional gates,
supplied with every operator,
allow on the job conversion to
three- or eight-position
operation as illustrated.
Two-, Three- or Eight-
Position Operation
The eight-position gate
controls the four functions
shown as “Up,” “Down,”
“Left” and “Right.” The
remaining four diagonal
positions each actuate two
adjacent functions; for
example, “Left Down”
actuates both “Left” and
“Down.” The operator may
be arranged for spring return
of handle to center position,
or maintained in up to eight
positions (see description of
maintained position operator).
Adjacent Functions
Maintained Position
For maintained position (non-
spring return), locate required
maintained position or
positions of operating lever
and add appropriate suffix
number to the catalog
number selected from the
table above.
Maintained Positions
On an eight-position gate,
when an adjacent vertical and
horizontal position are both
maintained, the included
diagonal position is also
maintained.
Note
1
Momentary operators—spring return to center. For maintained operators add suffix code from table on this page.
Example: 10250T45110. Operator without latch, maintained in left and right positions.
Contact Block Limitations Description
1
Catalog Number
Operator Only—AC Application Only
Four contact blocks max.—two in each position Four-position—without latch 10250T451_
Four-position—with latch 10250T461_
Hole Plug
Four contact blocks max.—two in each position To plug unused hole 10250TA7
Four-Position Joystick
Operator
Four-Position Joystick
Operator with Latch
Four-Position
Gate
or
Two-Position
Gate
Eight-Position
Gate
Three-Position
Gate
or or or
Up
Right
Up
Left
Up
Down Right
Down
RightLeft
Left
Down
Maintained Positions
Suffix
NumberUp Down Left Right
X— —— 1
—— — — 2
—X — — 3
—— X — 4
—— — — 5
X— X — 6
X— —X 7
—X X — 8
—X — X 9
—— X X 10
XX X — 11
XX —X 12
X— X X 13
—X X X 14
XX X X 15